PS9513 Datasheet, PDF (8/19 Pages) California Eastern Labs – 1 Mbps, OPEN COLLECTOR OUTPUT, FOR GATE DRIVE INTERFACE INTELLIGENT POWER MODULE 8-PIN DIP PHOTOCOUPLER

*1 Typical values at TA = 25 C.
*2 Test circuit for propagation delay time
PS9513,PS9513L1,PS9513L2 PS9513L3
*3 Test circuit for common mode transient immunity
USAGE CAUTIONS
1. This product is weak for static electricity by designed with high-speed integrated circuit so protect against static
electricity when handling.
2. By-pass capacitor of more than 0.1 F is used between VCC and GND near device. Also, ensure that the
distance between the leads of the photocoupler and capacitor is no more than 10 mm.
<R>
3. Pins 1, 4 (which is an NC^*1 pin) can either be connected directly to the GND pin on the LED side or left open.
Also, Pin 7 (which is an NC^*1 pin) can either be connected directly to the GND pin on the detector side or left
open.
Unconnected pins should not be used as a bypass for signals or for any other similar purpose because this
may degrade the internal noise environment of the device.
*1 NC: Non-Connection (No Connection)
4. Avoid storage at a high temperature and high humidity.
8
Data Sheet PN10679EJ03V0DS