PS9711 Datasheet, PDF (1/7 Pages) NEC – HIGH NOISE REDUCTION/HIGH-SPEED 10 Mbps, TOTEM-POLE OUTPUT TYPE 5-PIN SOP TOM PHOTOCOUPLER

HIGH NOISE REDUCTION/
HIGH SPEED 10 Mbps,
TOTEM-POLE OUTPUT TYPE
5 PIN SOP TOM OPTOCOUPLER
PS9711
FEATURES
• HIGH COMMON MODE TRANSIENT IMMUNITY
CMH, CML: ±10 kV/µs TYP
• SMALL PACKAGE
5 pin SOP
• HIGH SPEED RESPONSE
tPHL = 30 ns, tPLH = 35 ns TYP
• PULSE WIDTH DISTORTION
|tPHL-tPLH| = 7 ns TYP
• TOTEM-POLE OUTPUT
No Pull-up resistor required
• TAPE AND REEL AVAILABLE
DESCRIPTION
The PS9711 is an optically coupled high speed totem pole
isolator containing a GaAIAs LED on the light emitting diode
side (input side) and a photodiode and a signal processing
circuit on the light receiving side (output side) on one chip. It
is housed in a plastic SOP (Small Out-Line Package) for high
density applications.
APPLICATIONS
• COMPUTER AND PERIPHERAL DEVICES
• MEASUREMENT EQUIPMENT
• POWER SUPPLY
ELECTRICAL CHARACTERISTICS (TA = -40 to +85 °C, unless otherwise specified)
PART NUMBER
SYMBOLS
PARAMETERS
UNITS
VF
Forward Voltage, IF = 10 mA, TA = 25°C
V
IR
Reverse Current, VR = 3 V, TA = 25°C
µA
Ct
Capacitance, V = 0, f = 1.0 MHz, TA = 25°C
pF
IOH
High Level Output Current, VCC = VO = 5.5 V, IF = 250 µA
µA
VOH
High Level Output Voltage, VCC = 4.5 V, IF = 250 µA, IOH = -2 mA
V
VOL
Low Level Output Voltage, VCC = 4.5 V, IF = 7 mA, IO = 8 mA
V
ICCH
High Level Supply Current, VCC = 5.5 V, IF = 0 mA
mA
ICCL
Low Level Supply Current, VCC = 5.5 V, IF = 10 mA
mA
IOSH
High Level Output Short Circuit Current,
VCC = 5.5 V, VO =GND, IF = 0 mA, 10 ms or less
mA
IOSL
Low Level Output Short Circuit Current,
VCC = 5.5 V, VO =GND, IF = 8 mA, 10 ms or less
mA
IFHL
Threshold Input Current, High → Low, VCC = 5 V TA = 25°C
mA
IFLH
Threshold Input Current, Low → High, VCC = 5 V TA = 25°C
mA
RI-O
CI-O
tPHL
tPLH
|tPHL-tPLH|
CMH
CML
Isolation Resistance, Vin-out = 1 kVDC, RH = 40 to 60%, TA = 25°C
Isolation Capacitance, V = 0, f = 1.0 MHz, TA = 25°C
Propagation Delay Time, High → Low² , VCC = 5 V, IF = 7.5 mA
TA = 25°C
Propagation Delay Time, Low → High² ,VCC = 5 V, IF = 7.5 mA
TA = 25°C
Pulse Width Distortion, (PWD)²,VCC = 5 V, IF = 7.5 mA
Common Mode Transient Immunity at High Level Output³
VCC = 5 V, TA = 25°C, IF = 0 mA, VO(min) = 2 V , VCM = 100 V
Common Mode Transient Immunity at Low Level Output³
VCC = 5 V, TA = 25°C, IF = 7.5 mA, VO = 0.8 V (max) RL = 350 Ω
VCM = 1 kV
Ω
pF
ns
ns
ns
kV/µs
kV/µs
MIN
1.4
2.4
0.5
0.35
10¹¹
15
10
15
10
1
1
PS9711
TYP
1.65
30
1
3.0
0.38
11
12
-26
34
2.0
0.6
30
35
7
10
10
MAX
1.9
10
200
0.6
17
18
5
6
65
85
65
85
35
SEE NOTES ON NEXT PAGE
California Eastern Laboratories