CAT5111 Datasheet, PDF (1/7 Pages) Catalyst Semiconductor – 100-Tap Digitally Programmable Potentiometer (DPP) with Buffered Wiper

CAT5111
100-Tap Digitally Programmable Potentiometer (DPP™)
with Buffered Wiper
FEATURES
APPLICATIONS
ALOGEN ^FR
LEA _{D F REETM}
s 100-position linear taper potentiometer
s Non-volatile NVRAM wiper storage;
buffered wiper
s Low power CMOS technology
s Single supply operation: 2.5V-6.0V
s Increment up/down serial interface
s Resistance values: 10kΩ, 50kΩ and 100kΩ
s Available in PDIP, SOIC, TSSOP and MSOP packages
s Automated product calibration
s Remote control adjustments
s Offset, gain and zero control
s Tamper-proof calibrations
s Contrast, brightness and volume controls
s Motor controls and feedback systems
s Programmable analog functions
DESCRIPTION
The CAT5111 is a single digitally programmable
potentiometer (DPP™) designed as a electronic
replacement for mechanical potentiometers and trim
pots. Ideal for automated adjustments on high volume
production lines, they are also well suited for
applications where equipment requiring periodic
adjustment is either difficult to access or located in a
hazardous or remote environment.
The CAT5111 contains a 100-tap series resistor array
connected between two terminals R_H and R_L. An up/
down counter and decoder that are controlled by three
input pins, determines which tap is connected to the
wiper, R_WB. The CAT5111 wiper is buffered by an op
amp that operates rail to rail. The wiper setting, stored in
non-volatile NVRAM memory, is not lost when the device
is powered down and is automatically recalled when
power is returned. The wiper can be adjusted to test new
system values without effecting the stored
setting. Wiper-control of the CAT5111 is
accomplished with three input control pins, CS, U/D,
and INC. The INC input increments the wiper in the
direction which is determined by the logic state of
the U/D input. The CS input is used to select the
device and also store the wiper position prior to
power down.
The digitally programmable potentiometer can be
used as a buffered voltage divider. For applications
where the potentiometer is used as a 2-terminal variable
resistor, please refer to the CAT5113. The buffered
wiper of the CAT5111 is not compatible with that
application. DPPs bring variability and programmability
to a broad range of applications and are used primarily
to control, regulate or adjust a characteristic or parameter
of an analog circuit.
FUNCTIONAL DIAGRAM
V_CC
RH
U/D
Control
INC
and
Memory
CS
Power On Recall
GND
© 2004 by Catalyst Semiconductor, Inc.
Characteristics subject to change without notice
R_H
+
-
R _WB
R_L
1
+
–
RWB
RL
Electronic Potentiometer
Implementation
Doc. No. 2008, Rev. O