S151-0320XYZ-BB Datasheet, PDF (1/10 Pages) C&D Technologies – DC/DC Converter

Features
DC/D^DC^C/DC^Co^Cn^ovⁿe^vr^et^re^ter^r
Programmable, Single Output, 1.1V - 1.85Vout @ 60A
3.3V input, 0.8 to 2.5V output, 15A
5V input, 1.0 to 3.3V output, 15A
12.0V input, 1.5 to 5.0V output, 15A
✓ ^{High output 15A}
✓ ^{3.3V ±5%, 5/12V ±10% Input}
✓ ^{Regulation ±0.4% line and load}
✓ ^{Industry standard pin configuration}
✓ ^{High efficiency to 91%}
✓ ^{Remote Sense, Trim and Enable}
✓ ^{Short Circuit protection}
✓ ^{MTBF 2.9 million hours}
✓ ^{Output voltage trimmable down to 0.6V using the optional}
voltage reference
✓ Can source and sink output current
This unit is not fuse protected. User is responsible for providing system protection.
Consult factory for application information.
Specifications *
S151-03
S151-05
S151-12
Input Specifications
Input voltage range
External input capacitor
3.3V ± 10% 5.0V ± 10% 12V ± 10% Measured at +Vin pin
Minimum 680µF
See also note on pg 9 and charts on pg 7
Output Specifications
Standard output voltages
Output current
Load regulation
Line regulation
External output capacitor
Short circuit protection
0.8V
0.9V
1.2V
1.5V
1.8V
2.5V
15A
1.0V
1.2V
1.5V
1.8V
2.5V
3.3V
15A
1.5V
1.8V
2.5V
3.3V
5.0V
15A**
±0.5%
±0.5%
>150µF with maxESR = 100mΩ
18A (at 70°C) to 32A (at -40°C)
Outputs 0.8V and 1.0V trimmable down to 0.6V using the
on-board voltage reference (option 7 or F, see pg 2 and
trimming equations on pg 8). Standard setpoint accuracy
varies from ±1.5% at the low end of the output voltage
range, to ±3% at the high end. (see chart on pg 2)
Contact factory for tighter tolerances.
See note on pg 8 for trimming to different voltages.
200 LFM at 70°C (see also derating curves
page 5-6)
0 to 15A load
Over specified input voltage range
See also note on pg 9
General Specifications
Enable ***
Efficiency
Isolation
Switching frequency
Approvals and Standards
Protection
Operating Temperature ****
Storage Temperature
Weight
MTBF
ON-open or low / OFF-high (max 15V)
90% typical
Non-isolated
300kHz
UL 94V-0
Fusing
-40°C to 70°C
-40°C to 85°C
0.4 oz (11.3 gm)
2.7 million hours
See efficiency curves on pg 4
Fixed
Unit is not fused.
200 LFM at 70°C (see also derating curves)
Non-condensing
Per RAC PRISM at 50°C ambient and 200 LFM
* All specifications are typical at nominal input, full load at 25°C unless otherwise stated.
** Max 10A for 5.0V output.
*** Pull below 0.4V and sink greater than 50 µA or leave open to enable the SIP; pull above 2V (do not exceed 15V) and source greater than 150 µA
to disable the SIP.
**** The output capacitors must meet the max ESR = 100 mΩ requirement over the operating temperature range.
1150 Eglinton Avenue East
Toronto, Ontario M3C 1H7
1-866-740-1232
S151_084-S151-00_RevH_Jan18-2005.fm
www.cdtechno-cps.com
4607 S.E. International Way
Milwaukie, Oregon 97222
1-971-206-2800
1 of 10