CSPEMI204 Datasheet, PDF (3/6 Pages) California Micro Devices Corp – 2 Channel Headset EMI Filter with ESD Protection

Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
CSPEMI204
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
300
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS ^{(NOTE 1)}
SYMBOL
R₁
R₂
C₁
C₂
I_LEAK
V_SIG
V_ESD
V_CL
f_C1
f_C2
PARAMETER
Resistance
Resistance
Capacitance
Capacitance
Diode Leakage Current
Signal Voltage
Positive Clamp
Negative Clamp
In-system ESD Withstand Voltage
a) Human Body Model, MIL-STD-883,
Method 3015
b) Contact Discharge per IEC 61000-4-2
Level 4
Clamping Voltage during ESD Discharge
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
Cut-off frequency 1; Note 5
Cut-off frequency 2; Note 5
CONDITIONS
V_IN=5.0V
I_LOAD = 10mA
Notes 2 and 4
Notes 2,3 and 4
R = 10Ω, C = 100pF
R = 68Ω, C = 47pF
MIN TYP MAX UNITS
9
10
11
Ω
54
68
75
Ω
80
100 120
pF
38
47
57
pF
1.0
μA
5
7
15
V
-15
-10
-5
V
±15
kV
±8
kV
+15
V
-19
V
33
MHz
61
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1,
then clamping voltage is measured at Pin C1.
Note 4: The parameters are guaranteed by design.
Note 5: Z_SOURCE=50Ω, Z_LOAD=50Ω
© 2005 California Micro Devices Corp. All rights reserved.
09/28/05
490 N. McCarthy Blvd., Milpitas, CA 95035-5112 ● Tel: [phone] ● Fax: [phone] ● www.cmd.com 3