CSPEMI202A Datasheet, PDF (3/6 Pages) California Micro Devices Corp – 2 Channel Headset Microphone EMI Filter with ESD Protection

Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
CSPEMI202A
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
200
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS¹
SYMBOL PARAMETER
CONDITIONS
MIN TYP
MAX
UNITS
R₁
Resistance
61 68
75
Ω
C₁
Capacitance
38 47
56
pF
I_LEAK Diode Leakage Current
V_IN=5.0V
1.0
µA
V_SIG
Signal Voltage
Positive Clamp
Negative Clamp
I_LOAD = 10mA
5
7
15
V
-5 -10
-15
V
V_ESD In-system ESD Withstand Voltage
Notes 2,4 and 5
a) Human Body Model, MIL-STD-883,
±15
kV
Method 3015
b) Contact Discharge per IEC 61000-4-2
±8
kV
Level 4
V_CL Clamping Voltage during ESD Discharge Notes 2,3,4 and 5
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
+15
V
-19
V
f_C
Cut-off frequency
Z_SOURCE = 50Ω, Z_LOAD = 50Ω
R = 68Ω, C = 47pF
60
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1,
then clamping voltage is measured at Pin C1.
Note 4: Unused pins are left open
Note 5: These parameters are guaranteed by design and characterization.
© 2003 California Micro Devices Corp. All rights reserved.
10/09/03 430 N. McCarthy Blvd., Milpitas, CA 95035-5112 L Tel: [phone] L Fax: [phone] L www.calmicro.com
3