CM1423 Datasheet, PDF (3/10 Pages) California Micro Devices Corp – Secure Digital (SD) Card EMI Filter Array with ESD Protection

Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
CM1423
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
500
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS ^{(SEE NOTE 1)}
SYMBOL PARAMETER
CONDITIONS
MIN TYP MAX
R
Resistance
80
100
120
C
Capacitance
At 2.5V DC, 1MHz, 30mV
9
AC
12
15
V_DIODE Diode Standoff Voltage
I_DIODE = 10µA
5.5
I_LEAK Diode Leakage Current (reverse bias)
V_DIODE = 3.3V
100
V_SIG
Signal Voltage
Positive Clamp
Negative Clamp
I_LOAD = 10mA
I_LOAD = -10mA
5.6
6.8
9.0
-1.5
-0.8
-0.4
V_ESD In-system ESD Withstand Voltage
Notes 2,4 and 5
a) Human Body Model, MIL-STD-883,
±30
Method 3015
b) Contact Discharge per IEC 61000-4-2
±15
Level 4
V_CL
Clamping Voltage during ESD Discharge Notes 2,3,4 and 5
MIL-STD-883 (Method 3015), 8kV
Positive Transients
+12
Negative Transients
-7
f_C
Cut-off Frequency
Z_SOURCE=50Ω, Z_LOAD=50Ω
R = 100Ω, C = 12pF;
Note 5
145
UNITS
Ω
pF
V
nA
V
V
kV
kV
V
V
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A1,
then clamping voltage is measured at Pin C1.
Note 4: Unused pins are left open
Note 5: These parameters are guaranteed by design and characterization.
© 2005 California Micro Devices Corp. All rights reserved.
01/12/05 430 N. McCarthy Blvd., Milpitas, CA 95035-5112
▲ Tel: [phone] ▲ Fax: [phone] ▲ www.calmicro.com
3