CM1421 Datasheet, PDF (3/8 Pages) California Micro Devices Corp – 4-Channel LCD EMI Filter Array plus / 4-Channel ESD Protection Array

Specifications
PARAMETER
Storage Temperature Range
DC Power per Resistor
DC Package Power Rating
CM1421
ABSOLUTE MAXIMUM RATINGS
RATING
-65 to +150
100
500
UNITS
°C
mW
mW
PARAMETER
Operating Temperature Range
STANDARD OPERATING CONDITIONS
RATING
-40 to +85
UNITS
°C
ELECTRICAL OPERATING CHARACTERISTICS ^{(SEE NOTE1)}
SYMBOL
R
C
V_DIODE
I_LEAK
V_SIG
V_ESD
V_CL
f_C
PARAMETER
Resistance
Capacitance
Diode Standoff Voltage
Diode Leakage Current (reverse bias)
Signal Voltage
Positive Clamp
Negative Clamp
In-system ESD Withstand Voltage
a) Human Body Model, MIL-STD-883,
Method 3015
b) Contact Discharge per IEC 61000-4-2
Level 4
Clamping Voltage during ESD Discharge
MIL-STD-883 (Method 3015), 8kV
Positive Transients
Negative Transients
Cut-off Frequency
Z_SOURCE=50Ω, Z_LOAD=50Ω
CONDITIONS
At 2.5V DC
I_DIODE=10µA
V_DIODE=3.3V
I_LOAD = 10mA
Notes 2,4 and 5
Notes 2,3,4 and 5
R=100Ω, C=15pF
MIN TYP
80 100
12 15
5.5
100
5.6 6.8
-1.5 -0.8
±30
±15
MAX
120
18
9.0
-0.4
UNITS
Ω
pF
V
nA
V
V
kV
kV
+12
V
-7
V
120
MHz
Note 1: T_A=25°C unless otherwise specified.
Note 2: ESD applied to input and output pins with respect to GND, one at a time.
Note 3: Clamping voltage is measured at the opposite side of the EMI filter to the ESD pin. For example, if ESD is applied to Pin A2,
then clamping voltage is measured at Pin C2.
Note 4: Unused pins are left open
Note 5: These parameters are guaranteed by design and characterization.
© 2004 California Micro Devices Corp. All rights reserved.
04/27/04 430 N. McCarthy Blvd., Milpitas, CA 95035-5112 ▲ Tel: [phone] ▲ Fax: [phone] ▲ www.calmicro.com
3