CM2400-01 Datasheet, PDF (2/14 Pages) California Micro Devices Corp – Universal Serial Bus Transceiver with Level Translator

PACKAGE / PINOUT DIAGRAM
CM2400-01
SPND 5
V_M 4
V_P 3
RCV 2
OE ¹
6 78
9 D-
HBCC16
GND
17
10 D+
11 V_PO/V_O
12 V_MO/FSEO
16 15 14
13 V_REG
Note: This drawing is not to scale.
HBCC16 Package
Bottom View
PINS
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
PIN DESCRIPTIONS
NAME
OE
RCV
V_P
V_M
SPND
MODE
V_CC
USB_DET
D-
D+
V_PO/V_O
V_MO/FSEO
V_REG
V_BUS
V_PU
DESCRIPTION
Input for Output Enable (Active low). Enables transceiver driver to transmit data on the USB bus.
When OE pin = LOW, driver circuitry is enabled.
Differential receiver output of D+ and D- input data lines. The output state of RCV is preserved and
stable during an SE0 condition.
Single-ended D+ receiver output for detection of a single-ended zero or error conditions
Single-ended D- receiver output for detection of a single-ended zero or error conditions.
Suspend input. Allows the device to enter a low power state while the USB is inactive.
Mode input. Selects between differential (V_PO, V_MO) and single-ended mode (V_O, FSEO).
Supply voltage for digital I/O pins. Voltages supported: 1.65 to 3.3V.
I/O level USB detect output. Logic High indicates that a USB cable is present.
Negative USB data connection.
Positive USB data connection. In full-speed connect mode, connect to V_PU via a 1.5kΩ resistor. Tol-
erance of this resistor is defined in the USB specification REV 1.1 & 2.0
Driver data input.
Driver data input.
Regulated supply voltage output during USB operation of V_BUS. 1uF decoupling capacitor is
required.
Supply voltage input. Can be directly connected to USB V_BUS.
Pull-up supply voltage. Pin function is controlled by input ENUM.
© 2003 California Micro Devices Corp. All rights reserved.
2 430 N. McCarthy Blvd., Milpitas, CA 95035-5112 L Tel: [phone]
L Fax: [phone] L www.calmicro.com
10/01/03