BVM-S450 Datasheet, PDF (7/7 Pages) Bright View Electronic Co., LTD. – LED STRIP LIGHT

Bright View Electronics
LED STRIP LIGHT
BVM-S450 Series
■ CAUTIONS
1. Over voltage
A. Drive the product over the specified voltage rating (25VDC) per unit or per strip will damage
the product.
B. The product should not be used in reverse polarity.
C. It is recommended to use a power supply with overload (over-voltage, short circuit and
overheat) protection.
2. Hand soldering
A. It is recommended to use a tip temperature of 280 ^OC for less than 3 seconds (one times)
with a soldering iron capacity of 30W, if hand soldering of the connecting wire is required.
B. Be careful of the contaminations of hand soldering.
3. Storage & Handling
A. Open the anti-electrostatic bag only a short time before use.
B. The product should be storage in an environment with the relative humidity less than
90% RH (@30 degree C or less).
C. During installation, excess mechanical stress will damage the product. The minimum
bending radius of curvature is 5000mm. The maximum twist angle is 1 degree.
D. The product is not waterproof. Excess moisture may also damage the product.
Date：2007/8/29
Page：7 of 7
Version - B