BVM-SFRGB2S-T Datasheet, PDF (5/5 Pages) Bright View Electronic Co., LTD. – RGB FLEXSTRIP LIGHT

Bright View Electronics
RGB FLEXSTRIP LIGHT
■ CAUTIONS
BVM-SFRGB2S-T
1. Bright View Electronics reserves the rights to modify specifications and remove availability
of products at any time without notice.
2. Solder connection should only be performed on designated solder pads(marked +/-).
During soldering, do not execeed the maximum soldering time of 10 seconds
and the maximum soldering temperature of 260 ℃.
3. Correct electrical polarity needs to be observed. Inadequate polarity may cause the destroy
of the LED module.
4. In addition to other specific application concerns and local safety codes,
following basic safety features are required when using power supply:
﹒overload protection
﹒short circuit protection
﹒over heat protection
﹒correct output voltage, including consideration for ripple and spikes
5. Make sure that the power supply has enough power to operate the total load.
6. When mounting on metallic ,it requires the electrical isolation between module and
mounting surface.
7.Customer's desired lengths of minimum 135mm and its multiple can be made by breaking
at the cutting mark of FPC.
8.The FPC (No. BVM-SFRGB2S ) can be operated at maximum current of 1.5A.
9.This product is not waterproof and precaution should be taken to keep from exposure to moisture.
Date：2008/05/13
Page ：5 of 5
Version B