BVM-SF5C01 Datasheet, PDF (5/5 Pages) Bright View Electronic Co., LTD. – FLEXSTRIP LIGHT

Bright View Electronics
FLEXSTRIP LIGHT
BVM-SF5C01 SERIES
■ CAUTIONS
1. Solder connection should only be performed on designated solder pads(marked +/-).
During soldering, do not execeed the maximum soldering time of 10 seconds
and the maximum soldering temperature of 260℃.
2. Correct electrical polarity needs to be observed. Wrong polarity may destroy the LED module.
3. When using power supply the following basic safety features are required, in additional
to any other specific application concerns and local safety codes:
﹒overload protection
﹒short circuit protection
﹒over heat protection
﹒correct output voltage, including consideration for ripple and spikes
4. Make ensure that the power supply is of adequate power to operate the total load.
5. When mounting on metallic surface, there needs to be a electrical isolation between module and
the mounting surface.
6.Customer's desired lengths of minimum 125mm and its multiple can be made by breaking
at the cutting mark of the LED strip.
7.This product is not waterproof and precaution should be taken to keep from exposure to moisture.
8.The FPC (No. BVM-SP5 Series) can be operated at maximum length of 8 meter.
9.Pay attention to standard ESD precautions when installing the LED module.
Date：2008/09/22
Page ：5 of 5
Version-A