BVS-166WT2 Datasheet, PDF (4/5 Pages) Bright View Electronic Co., LTD. – ULTRA BRIGHTNESS SMD LED

BRIGHT VIEW
ELECTRONICS CO.,LTD
SMD APPLICATION ( PB FREE SOLDERING )
Apply to BVS-3XX 1XX series.
Description:
(1) Manual soldering (We do not recommend this method strongly.)
(1.1) To prevent cracking,please bake (65 ,24hrs)before soldering.
(1.2) Temperature at tip of iron: 250 Max.(25W)
(1.3) It's banned to load any stress on the resin during soldering.
(1.4) Soldering time: 3 sec. Max.(one time only)
(2) Reflow Soldering
(2.1) To prevent cracking,please bake (65 ,24hrs)before soldering.
(2.2) When soldering,do not put stress on the LEDs during heating.
(2.3) Never take next process until the component is cooled down to room
temperature after reflow.
(2.4) After soldering,do not warp the circuit board.
(2.5) The recommended reflow soldering profile(measuring on the surface
of the LED resin)is following:
245 C MAX.
10 SEC. MAX.
217
217
150
TEMPERATURE _{1 /SEC. MAX.}
50 SEC. MAX.
~25
210 SEC. MIN.
100 SEC. MAX.
0.5 /SEC MAX.
~75
TIME
The reflow temperature 240 ~245 is recommended and the soldering temperature
should be not higher than 245 (one time only)
DOC. NO.:S-QW-K002
2006 / 02 / 08 - C