BVS-166RW2 Datasheet, PDF (2/3 Pages) Bright View Electronic Co., LTD. – SUPER BRIGHTNESS SMD LED

BRIGHT VIEW
ELECTRONICS CO.,LTD
SMD APPLICATION ( PB FREE SOLDERING )
Apply to BVS-3XXΕ1XX series.
Description:
(1) Manual soldering (We do not recommend this method strongly.)
(1.1) To prevent cracking,please bake (65к,24hrs)before soldering.
(1.2) Temperature at tip of iron: 250к Max.(25W)
(1.3) It's banned to load any stress on the resin during soldering.
(1.4) Soldering time: 3 sec. Max.(one time only)
(2) Reflow Soldering
(2.1) To prevent cracking,please bake (65к,24hrs)before soldering.
(2.2) When soldering,do not put stress on the LEDs during heating.
(2.3) Never take next process until the component is cooled down to room
temperature after reflow.
(2.4) After soldering,do not warp the circuit board.
(2.5) The recommended reflow soldering profile(measuring on the surface
of the LED resin)is following:
245 C MAX.
10 SEC. MAX.
TEMPERATURE _{1к/SEC. MAX.}
150к
217к
217к
50 SEC. MAX.
~25к
210 SEC. MIN.
100 SEC. MAX.
0.5к/SEC MAX.
~75к
TIME
The reflow temperature 240к~245к is recommended and the soldering temperature
should be not higher than 245к(one time only)
2005 / 10 / 20 - B