English
Language : 

OPA337 Datasheet, PDF (8/9 Pages) Burr-Brown (TI) – MicroSIZE, Single-Supply CMOS OPERATIONAL AMPLIFIERS MicroAmplifier ™ Series
Figure 4 shows a compensation technique using an inverting
configuration. The low frequency gain is set by the resistor
ratio while the high frequency gain is set by the capacitor
ratio. As with the noninverting circuit, for frequencies above
fC the gain must be greater than the recommended minimum
stable gain for the op amp.
Improved slew rate versus OPA337
(see Figure 5).
R1
5kΩ
VIN
C1
150pF
C2
15pF
R2
10kΩ
OPA338
VOUT
The capacitor values shown are the nearest standard values.
Capacitor values may need to be adjusted slightly to opti-
mize performance. For more detailed information, consult
the OPA686 product data sheet.
Figure 5 shows the large-signal transient response using the
circuit given in Figure 4. As shown, the OPA338 is stable in
low gain applications and provides improved slew rate
performance when compared to the OPA337.
OPA338
OPA337
1
C2 = 2πfCR2 , C1 = (GH –1) • C2
Where GH is the high frequency gain,
GH = 1 + C1/C2
FIGURE 4. Inverting Compensation Circuit of OPA338 for
Low Gain.
Resistors R1 and R2 are chosen to set the desired dc signal
gain. Then the value for C2 is determined as follows:
C2 = 1/(2πfCR2)
C1 is determined from the desired high frequency gain (GH):
C1 = (GH – 1) • C2
For a desired dc gain of 2 and high frequency gain of 10, the
following resistor and capacitor values result:
R1 = 10kΩ
R2 = 5kΩ
C1 = 150pF
C2 = 15pF
2µs/div
FIGURE 5. G = 2, Slew-Rate Comparison of OPA338 and
OPA337.
TYPICAL APPLICATION
Figure 6 shows the OPA2337 in a typical application. The
ADS7822 is a 12-bit, micro-power sampling analog-to-
digital converter available in the tiny MSOP-8 package. As
with the OPA2337, it operates with a supply voltage as
low as +2.7V. When used with the miniature SOT23-8
package of the OPA2337, the circuit is ideal for space-
limited and low power applications. In addition, OPA2337’s
high input impedance allows large value resistors to be
used which results in small physical capacitors, further
reducing circuit size. For further information, consult the
ADS7822 product data sheet.
® OPA337, OPA2337
OPA338, OPA2338
8