OPA340_06 Datasheet, PDF (3/20 Pages) Burr-Brown (TI) – SINGLE-SUPPLY, RAIL-TO-RAIL OPERATIONAL AMPLIFIERS MicroAmplifier TM Series

PIN CONFIGURATIONS
Top View
OPA4340
Out A 1
–In A 2
A
D
+In A 3
V+ 4
+In B 5
B
C
–In B 6
Out B 7
SOIC/DIP
14 Out D
13 –In D
12 +In D
11 V–
10 +In C
9 –In C
8 Out C
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage ................................................................................... 5.5V
Signal Input Terminals, Voltage⁽²⁾ .................... (V–) –0.5V to (V+) +0.5V
Current⁽²⁾ .................................................... 10mA
Output Short-Circuit⁽³⁾ .............................................................. Continuous
Operating Temperature ................................................. –55°C to +125°C
Storage Temperature ..................................................... –55°C to +125°C
Junction Temperature ...................................................................... 150°C
Lead Temperature (soldering, 10s) ................................................. 300°C
NOTES: (1) Stresses above these ratings may cause permanent damage.
(2) Input terminals are diode-clamped to the power supply rails. Input signals
that can swing more than 0.5V beyond the supply rails should be current-
limited to 10mA or less. (3) Short-circuit to ground, one amplifier per
package.
PACKAGE/ORDERING INFORMATION
PRODUCT
PACKAGE
PACKAGE
DRAWING
NUMBER⁽¹⁾
SPECIFIED
TEMPERATURE
RANGE
PACKAGE
MARKING
ORDERING
NUMBER⁽²⁾
TRANSPORT
MEDIA
Single
OPA340NA
"
OPA340PA
OPA340UA
5-Lead SOT-23-5
"
8-Pin DIP
SO-8 Surface-Mount
331
–40°C to +85°C
A40
OPA340NA-250
Tape and Reel
"
"
"
OPA340NA-3K
Tape and Reel
006
–40°C to +85°C
OPA340PA
OPA340PA
Rails
182
–40°C to +85°C
OPA340UA
OPA340UA
Rails⁽³⁾
Dual
OPA2340EA
"
OPA2340PA
OPA2340UA
Quad
OPA4340EA
"
OPA4340PA
OPA4340UA
MSOP-8 Surface-Mount
"
8-Pin DIP
SO-8 Surface-Mount
SSOP-16 Surface-Mount
"
14-Pin DIP
SO-14 Surface Mount
337
–40°C to +85°C
A40A
OPA2340EA-250
Tape and Reel
"
"
"
OPA2340EA-2500 Tape and Reel
006
–40°C to +85°C
OPA2340PA
OPA2340PA
Rails
182
–40°C to +85°C
OPA2340UA
OPA2340UA
Rails⁽³⁾
322
–40°C to +85°C
OPA4340EA
OPA4340EA-250
Tape and Reel
"
"
"
OPA4340EA-2500 Tape and Reel
010
–40°C to +85°C
OPA4340PA
OPA4340PA
Rails
235
–40°C to +85°C
OPA4340UA
OPA4340UA
Rails⁽³⁾
NOTES: (1) For detailed drawing and dimension table, please see end of data sheet, or Appendix C of Burr-Brown IC Data Book. (2) Models with -250, -2500, and
-3K are available only in Tape and Reel in the quantities indicated (e.g., -250 indicates 250 devices per reel). Ordering 3000 pieces of “OPA340NA-3K” will get
a single 3000 piece Tape and Reel. For detailed Tape and Reel mechanical information, refer to Appendix B of Burr-Brown IC Data Book. (3) SO-8 and SO-14
models also available in Tape and Reel.
The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN assumes no responsibility
for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject to change without notice. No patent rights or
licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not authorize or warrant any BURR-BROWN product for use in life support
devices and/or systems.
®
3
OPA340/2340/4340