OPA277 Datasheet, PDF (3/9 Pages) Burr-Brown (TI) – High Precision OPERATIONAL AMPLIFIERS

SPECIFICATIONS: V_S = ±5V to V_S = ±15V (CONT)
At T_A = +25°C, and R_L = 2kΩ, unless otherwise noted.
Boldface limits apply over the specified temperature range, –40°C to +85°C.
PARAMETER
POWER SUPPLY
Specified Voltage Range
V_S
Operating Voltage Range
Quiescent Current (per amplifier)
I_Q
T_A = –40°C to +85°C
TEMPERATURE RANGE
Specified Range
Operating Range
Storage Range
Thermal Resistance
θ_JA
SO-8 Surface-Mount
8-Pin DIP
14-Pin DIP
SO-14 Surface-Mount
T Specifications same as OPA277P, U.
NOTE: (1) V_S = ±15V.
CONDITION
I_O = 0
I_O = 0
OPA277P, U
OPA2277P, U
MIN
TYP⁽¹⁾ MAX
±5
±15
±2
±18
±790 ±825
±900
–40
85
–55
125
–55
125
150
100
80
100
OPA277PA, UA
OPA2277PA, UA
OPA4277PA, UA
MIN
TYP⁽¹⁾ MAX
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
T
UNITS
V
V
µA
µA
°C
°C
°C
°C/W
°C/W
°C/W
°C/W
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage .................................................................................... 36V
Input Voltage ..................................................... (V–) –0.7V to (V+) +0.7V
Output Short-Circuit⁽²⁾ .............................................................. Continuous
Operating Temperature .................................................. –55°C to +125°C
Storage Temperature ..................................................... –55°C to +125°C
Junction Temperature ...................................................................... 150°C
Lead Temperature (soldering, 10s) ................................................. 300°C
NOTE: (1) Stresses above these rating may cause permanent damage.
Exposure to absolute maximum conditions for extended periods may degrade
device reliability. (2) Short-circuit to ground, one amplifier per package.
PACKAGE/ORDERING INFORMATION
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
PRODUCT
OFFSET
VOLTAGE
max, µV
OFFSET
VOLTAGE DRIFT
max, µV/°C
PACKAGE
PACKAGE
DRAWING
NUMBER⁽¹⁾
TEMPERATURE
RANGE
ORDERING
NUMBER(2)
TRANSPORT
MEDIA
Single
OPA277PA
±50
OPA277P
±20
OPA277UA
±50
"
"
OPA277U
±20
"
"
±1
±0.15
±1
"
±0.15
"
8-Pin DIP
006
–40°C to +85°C
OPA277PA
Rails
8-Pin DIP
006
–40°C to +85°C
OPA277P
Rails
SO-8 Surface Mount
182
–40°C to +85°C
OPA277UA
Rails
"
"
"
OPA277UA/2K5 Tape and Reel
SO-8 Surface Mount
182
–40°C to +85°C
OPA277U
Rails
"
"
"
OPA277U/2K5 Tape and Reel
Dual
OPA2277PA
±50
OPA2277P
±25
OPA2277UA
±50
"
"
OPA2277U
±25
"
"
±1
±0.25
±1
"
±0.25
"
8-Pin DIP
006
–40°C to +85°C
OPA2277PA
Rails
8-Pin DIP
006
–40°C to +85°C
OPA2277P
Rails
SO-8 Surface Mount
182
–40°C to +85°C
OPA2277UA
Rails
"
"
"
OPA2277UA/2K5 Tape and Reel
SO-8 Surface Mount
182
–40°C to +85°C
OPA2277U
Rails
"
"
"
OPA2277U/2K5 Tape and Reel
Quad
OPA4277PA
±50
OPA4277UA
±50
"
"
±1
14-Pin DIP
010
–40°C to +85°C
OPA4277PA
Rails
±1
SO-14 Surface Mount
235
–40°C to +85°C
OPA4277UA
Rails
"
"
"
"
OPA4277UA/2K5 Tape and Reel
NOTE: (1) For detailed drawing and dimension table, please see end of data sheet, or Appendix C of Burr-Brown IC Data Book. (2) Products followed by a slash
(/) are only available in Tape and Reel in the quantities indicated (e.g. /2K5 indicates 2500 devices per reel). Ordering 2500 pieces of “OPA277UA/2K5” will get
a single 2500 piece Tape and Reel. For detailed Tape and Reel mechanical information, refer to Appendix B of Burr-Brown IC Data Book.
®
3
OPA277, 2277, 4277