OPA2604 Datasheet, PDF (3/12 Pages) Burr-Brown (TI) – Dual FET-Input, Low Distortion OPERATIONAL AMPLIFIER

PIN CONFIGURATION
Top View
Output A 1
–In A 2
+In A 3
V– 4
DIP/SOIC
8 V+
7 Output B
6 –In B
5 +In B
ELECTROSTATIC
DISCHARGE SENSITIVITY
Any integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with ap-
propriate precautions. Failure to observe proper handling and
installation procedures can cause damage.
ESD damage can range from subtle performance degradation
to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric
changes could cause the device not to meet published speci-
fications.
ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Power Supply Voltage ....................................................................... ±25V
Input Voltage ............................................................. (V–)–1V to (V+)+1V
Output Short Circuit to Ground ............................................... Continuous
Operating Temperature ................................................. –40°C to +100°C
Storage Temperature ..................................................... –40°C to +125°C
Junction Temperature .................................................................... +150°C
Lead Temperature (soldering, 10s) AP ......................................... +300°C
Lead Temperature (soldering, 3s) AU .......................................... +260°C
NOTE: (1) Stresses above these ratings may cause permanent damage.
ORDERING INFORMATION
PRODUCT
OPA2604AP
OPA2604AU
PACKAGE
8-Pin Plastic DIP
SO-8 Surface-Mount
TEMP. RANGE
–25°C to +85°C
–25°C to +85°C
PACKAGING INFORMATION
PRODUCT
PACKAGE
PACKAGE DRAWING
NUMBER⁽¹⁾
OPA2604AP
8-Pin Plastic DIP
006
OPA2604AU
SO-8 Surface-Mount
182
NOTE: (1) For detailed drawing and dimension table, please see end of data
sheet, or Appendix C of Burr-Brown IC Data Book.
®
3
OPA2604