OPA134_071 Datasheet, PDF (3/14 Pages) Burr-Brown (TI) – High Performance AUDIO OPERATIONAL AMPLIFIERS

ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Supply Voltage, V+ to V– .................................................................... 36V
Input Voltage .................................................... (V–) –0.7V to (V+) +0.7V
Output Short-Circuit⁽²⁾ .............................................................. Continuous
Operating Temperature ................................................. –40°C to +125°C
Storage Temperature ..................................................... –55°C to +125°C
Junction Temperature ...................................................................... 150°C
Lead Temperature (soldering, 10s) ................................................. 300°C
NOTES: (1) Stresses above these ratings may cause permanent damage.
(2) Short-circuit to ground, one amplifier per package.
PACKAGE/ORDERING INFORMATION
PRODUCT
PACKAGE
PACKAGE
DRAWING TEMPERATURE
NUMBER⁽¹⁾
RANGE
Single
OPA134PA
OPA134UA
8-Pin Plastic DIP
006
SO-8 Surface-Mount
182
–40°C to +85°C
–40°C to +85°C
Dual
OPA2134PA
8-Pin Plastic DIP
006
OPA2134UA
SO-8 Surface-Mount
182
–40°C to +85°C
–40°C to +85°C
Quad
OPA4134PA
14-Pin Plastic DIP
010
OPA4134UA
SO-14 Surface-Mount
235
–40°C to +85°C
–40°C to +85°C
NOTE: (1) For detailed drawing and dimension table, please see end of data
sheet, or Appendix C of Burr-Brown IC Data Book.
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
TYPICAL PERFORMANCE CURVES
At T_A = +25°C, V_S = ±15V, R_L = 2kΩ, unless otherwise noted.
TOTAL HARMONIC DISTORTION + NOISE
vs FREQUENCY
0.1
R_L
2kΩ
0.01
600Ω
0.001
G = +10
0.0001
G = +1
0.00001
10
100
V_O = 3Vrms
1k
10k
Frequency (Hz)
100k
SMPTE INTERMODULATION DISTORTION
vs OUTPUT AMPLITUDE
5
G = +1
f = 1kHz
1 _{RL = 2kΩ}
0.1
0.010
OPA134
OP176
OPA134
Baseline
0.001
0.0005
30m
0.1
1
10
30
Output Amplitude (Vpp)
The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN assumes
no responsibility for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject to change
without notice. No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not authorize or warrant
any BURR-BROWN product for use in life support devices and/or systems.
®
3
OPA134/2134/4134