ADS931 Datasheet, PDF (3/12 Pages) Burr-Brown (TI) – 8-Bit, 30MHz Sampling ANALOG-TO-DIGITAL CONVERTER

SPECIFICATIONS (CONT)
At T_A = full specified temperature range unless otherwise noted. +V_S = LV_DD = +3V, specified single-ended input (1V to 2V) and sampling rate = 30MHz, unless
otherwise specified. The input range is 2.25V to 3.25V when specified for +5V operation.
PARAMETER
CONDITIONS
ADS931E
MIN
TYP
MAX
UNITS
POWER SUPPLY REQUIREMENTS
Supply Voltage: +V_S
Supply Current: +I_S
Power Dissipation
Power Dissipation (Power Down)
Thermal Resistance, θ_JA
28-Lead SSOP
Operating
V_S = +3V
V_S = +3V
V_S = +5V
V_S = +3V
V_S = +5V
+2.7
+3.0
+5.5
V
23
29
mA
69
87
mW
154
mW
10
mW
15
mW
50
°C/W
NOTES: (1) The single-ended input range is set by REFB and REFT values. (2) Spurious Free Dynamic Range refers to the magnitude of the largest harmonic.
(3) dBFS is dB relative to full scale. (4) Two-tone intermodulation distortion is referred to as the largest fundamental tone. (5) Based on (SINAD –1.76)/6.02. (6) No
“Rollover” of bits. (7) Offset deviation from ideal negative full scale.
ABSOLUTE MAXIMUM RATINGS
+V_S ....................................................................................................... +6V
Analog Input ........................................................... (–0.3V) to (+V_S +0.3V)
Logic Input ............................................................. (–0.3V) to (+V_S +0.3V)
Case Temperature ......................................................................... +100°C
Junction Temperature .................................................................... +150°C
Storage Temperature ..................................................................... +150°C
PACKAGE/ORDERING INFORMATION
PRODUCT
ADS931E
PACKAGE
28-Lead SSOP
PACKAGE
DRAWING
NUMBER⁽¹⁾
324
TEMPERATURE
RANGE
–40°C to +85°C
NOTE: (1) For detailed drawing and dimension table, please see end of data
sheet, or Appendix C of Burr-Brown IC Data Book.
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Burr-Brown
recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degradation
to complete device failure. Precision integrated circuits may
be more susceptible to damage because very small parametric
changes could cause the device not to meet its published
specifications.
The information provided herein is believed to be reliable; however, BURR-BROWN assumes no responsibility for inaccuracies or omissions. BURR-BROWN
assumes no responsibility for the use of this information, and all use of such information shall be entirely at the user’s own risk. Prices and specifications are subject
to change without notice. No patent rights or licenses to any of the circuits described herein are implied or granted to any third party. BURR-BROWN does not
authorize or warrant any BURR-BROWN product for use in life support devices and/or systems.
®
3
ADS931