VCA2613 Datasheet, PDF (2/16 Pages) Burr-Brown (TI) – Dual, VARIABLE GAIN AMPLIFIER with Low-Noise Preamp

ABSOLUTE MAXIMUM RATINGS⁽¹⁾
Power Supply (+V_S) ............................................................................. +6V
Analog Input ............................................................. –0.3V to (+V_S + 0.3V)
Logic Input ............................................................... –0.3V to (+V_S + 0.3V)
Case Temperature ......................................................................... +100°C
Junction Temperature .................................................................... +150°C
Storage Temperature ...................................................... –40°C to +150°C
NOTE: (1) Stresses above those listed under “Absolute Maximum Ratings” may
cause permanent damage to the device. Exposure to absolute maximum
conditions for extended periods may affect device reliability.
PACKAGE/ORDERING INFORMATION⁽¹⁾
ELECTROSTATIC
DISCHARGE SENSITIVITY
This integrated circuit can be damaged by ESD. Texas Instru-
ments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling
and installation procedures can cause damage.
ESD damage can range from subtle performance degrada-
tion to complete device failure. Precision integrated circuits
may be more susceptible to damage because very small
parametric changes could cause the device not to meet its
published specifications.
PRODUCT
PACKAGE-LEAD
PACKAGE
DESIGNATOR
PACKAGE
MARKING
ORDERING
NUMBER
TRANSPORT
MEDIA, QUANTITY
VCA2613Y
"
TQFP-48
"
PFB
VCA2613
VCA2613Y/250
Tape and Reel, 250
"
"
VCA2613Y/2K
Tape and Reel, 2000
NOTE: (1) For the most current package and ordering information, see the Package Option Addendum located at the end of this data sheet.
ELECTRICAL CHARACTERISTICS
At T_A = +25°C, V_DDA = V_DDB = V_DDR = +5V, load resistance = 500Ω on each output to ground, MGS = 011, LNP = 22dB and f_IN = 5MHz, unless otherwise noted.
The input to the preamp (LNP) is single-ended, and the output from the VCA is single-ended unless otherwise noted.
PARAMETER
CONDITIONS
VCA2613Y
MIN
TYP
MAX
UNITS
PREAMPLIFIER
Input Resistance
Input Capacitance
Input Bias Current
CMRR
Maximum Input Voltage
Input Voltage Noise⁽¹⁾
Input Current Noise
Noise Figure, R_S = 75Ω, R_IN = 75Ω⁽¹⁾
Bandwidth
f = 1MHz, VCA_CNTL = 0.2V
Preamp Gain = +5dB
Preamp Gain = +25dB
Preamp Gain = +5dB
Preamp Gain = +25dB
Independent of Gain
R_F = 550Ω, Preamp Gain = 22dB,
PGA Gain = 39dB
Gain = 22dB
PROGRAMMABLE VARIABLE GAIN AMPLIFIER
Peak Input Voltage
Differential
–3dB Bandwidth
Slew Rate
Output Signal Range
Output Impedance
R_L ≥ 500Ω Each Side to Ground
f = 5MHz
Output Short-Circuit Current
Third Harmonic Distortion
Second Harmonic Distortion
IMD, Two-Tone
1dB Compression Point
f = 5MHz, V_OUT = 1V_PP, VCA_CNTL = 3.0V
f = 5MHz, V_OUT = 1V_PP, VCA_CNTL = 3.0V
V_OUT = 2V_PP, f = 1MHz
V_OUT = 2V_PP, f = 10MHz
f = 5MHz, Output Referred, Differential
Crosstalk
Group Delay Variation
V_OUT = 1V_PP, f = 1MHz, Max Gain Both Channels
1MHz < f < 10MHz, Full Gain Range
DC Output Level, V_IN = 0
ACCURACY
Gain Slope
Gain Error
Output Offset Voltage
Total Gain
CNTL = 0.2V
CNTL = 3.0V
GAIN CONTROL INTERFACE
Input Voltage (VCA_CNTL) Range
Input Resistance
Response Time
45dB Gain Change, MGS = 111
POWER SUPPLY
Operating Temperature Range
Specified Operating Range
Power Dissipation
Operating, Both Channels
NOTE: (1) For preamp driving VGA. (2) Referenced to best fit dB-linear curve.
–45
–45
18
47
–40
4.75
600
15
1
50
1
112
3.5
1.0
0.35
6.2
80
2
40
300
2
1
±40
–71
–63
–80
–80
6
–68
±2
2.5
10.9
±50
21
50
0.2 to 3.0
1
0.2
5.0
410
±1⁽²⁾
24
53
+85
5.25
495
kΩ
pF
nA
dB
V_PP
mV_PP
nV/√Hz
nV/√Hz
pA/√Hz
dB
MHz
V_PP
MHz
V/µs
V_PP
Ω
mA
dBc
dBc
dBc
dBc
V_PP
dB
ns
V
dB/V
dB
mV
dB
dB
V
MΩ
µs
°C
V
mW
2
VCA2613
www.ti.com
SBOS179D