OPA2607 Datasheet, PDF (2/13 Pages) Burr-Brown (TI) – Dual, High Output, Current-Feedback OPERATIONAL AMPLIFIER

SPECIFICATIONS: V_S = ±12V
R_F = 1.21kΩ, R_L = 100Ω, and G = +8, unless otherwise noted.
OPA2607H, U, N
PARAMETER
CONDITIONS
TYP
+25°C
+25°C⁽²⁾
GUARANTEED
0°C to
70°C⁽³⁾
–40°C to
+85°C⁽³⁾
UNITS
MIN/ TEST
MAX LEVEL⁽¹⁾
AC PERFORMANCE (see Figure 1)
Small-Signal Bandwidth (V_O = 0.5Vp-p)
Bandwidth for 0.1dB Gain Flatness
Large-Signal Bandwidth
Slew Rate
Rise/Fall Time
Spurious Free Dynamic Range⁽⁴⁾
Input Voltage Noise
Non-Inverting Input Current Noise
Inverting Input Current Noise
Differential Gain
Differential Phase
Channel-to-Channel Crosstalk
G = +1, R_F = 1.50kΩ
G = +2, R_F = 1.43kΩ
G = +4, R_F = 1.37kΩ
G = +8, R_F = 1.21kΩ
G = +8, V_O = 0.5Vp-p
G = +8, V_O = 20Vp-p
G = +8, V_O = 20V Step
G = +8, V_O = 0.5V Step
V_O = 2Vp-p, 1MHz, R_L = 100Ω
V_O = 20Vp-p, 150kHz, R_L = 150Ω
NTSC, G = +2, R_L = 150Ω
NTSC, G = +2, R_L = 150Ω
f = 1MHz
35
28
25
25
19
18
6
13
10.6
9.0
600
470
400
14
18
20
77
66
60
75
70
58
1.7
2.0
2.6
11
13
13
15
17
17
0.01
0.01
–60
MHz typ C
MHz typ C
MHz typ C
17
MHz min B
MHz typ C
7.9
MHz min B
350
V/µs min B
21
ns
min B
57
dB
min B
57
dB
min B
2.7
nV/√Hz max B
13
pA/√Hz max B
17
pA/√Hz max B
%
typ C
degrees typ C
dB
typ C
DC PERFORMANCE⁽⁵⁾
Open-Loop Transimpedance Gain
Input Offset Voltage
Average Offset Voltage Drift
Non-Inverting Input Bias Current
Average Non-Inverting Input Bias Current Drift
Inverting Input Bias Current
Average Inverting Input Bias Current Drift
INPUT
Common-Mode Input Range (CMIR)
Common-Mode Rejection Ratio (CMRR)
Non-Inverting Input Impedance
Inverting Input Resistance
V_O = 0V, R_L = 100Ω
V_CM = 0V
V_CM = 0V
V_CM = 0V
V_CM = 0V
V_CM = 0V
V_CM = 0V
V_CM = 0V
Open-Loop
950
440
±1.5
±7
±3
±12
±4
±40
±10.3
64
250 || 4
33
±10.0
53
390
±8
–20
±15
–70
±58
–380
±9.9
52
310
±8.5
–25
±20
–100
±70
–425
kΩ
min A
mV
max A
µV/°C max B
µA
max A
nA/°C max B
µA
max A
nA/°C max B
±9.8
V
min A
51
dB
min A
kΩ || pF typ C
Ω
typ C
OUTPUT
Voltage Output Swing
Current Output, Sourcing
Current Output, Sinking
Closed-Loop Output Impedance
No Load, Hard Limit
R_L = 100Ω, Hard Limit
R_L = 150Ω, SFDR > 67dB, 150kHz
V_O = 0
V_O = 0
G = +8, f ≤ 10kHz
±11.2
±10.5
±10.2
310
250
0.02
±10.9
±9.9
210
180
±10.8
±9.8
175
150
±10.7
±9.7
140
110
V
min A
V
min A
V
typ C
mA
min A
mA
min A
Ω
typ C
Power Control (SO-14 only)
Maximum Logic 0
Minimum Logic 1
Logic Input Current
Supply Current at Full Power
Supply Current at Power Cutback
Supply Current at Idle Power
Supply Current at Shutdown
Output Impedance in Idle Power
Output Impedance in Shutdown
Shutdown Isolation
Maximum Adjusted Quiescent Current
Minimum Adjusted Quiescent Current
POWER SUPPLY
Minimum Operating Voltage
Specified Operating Voltage
Maximum Operating Voltage
Maximum Quiescent Current
Minimum Quiescent Current
Power Supply Rejection Ratio (PSRR)
DIG_REF = Gnd
A0, A1
A0, A1
0V to 4.5V
A0 = 1, A1 = 1, I_ADJ = open
A0 = 0, A1 = 1, I_ADJ = open
A0 = 1, A1 = 0, I_ADJ = open
A0 = 0, A1 = 0, I_ADJ = open
Closed-Loop, f < 1MHz
G = +8, 1MHz
A0 = 1, A1 = 1, I_ADJ at +V_S
A0 = 1, A1 = 1, I_ADJ at –V_S
Total Both Channels, Full Power
Total Both Channels, Full Power
f ≤ 10kHz
0.8
2
60
16
13
3.8
1.3
0.7
350 || 17
75
20
12
V
max C
V
min C
µA
max C
mA
typ C
mA
typ C
mA
typ C
mA
typ C
Ω
typ C
kΩ || pF typ C
dB
typ C
mA
typ C
mA
typ C
±6
±6
±6
V
min B
±12
V
typ C
±16
±16
±16
V
max A
16
16.8
17
17.5
mA
max A
16
15.2
13.8
13.3
mA
min A
68
61
59
57
dB
min A
TEMPERATURE RANGE
Specification: H, U, N
Thermal Resistance, θ_JA
H PSO-8 Power Package⁽⁶⁾
U SO-8
N PSO-14 Power Package⁽⁶⁾
Junction-to-Ambient
–40 to +85
50
125
45
°C
typ C
°C/W typ C
°C/W typ C
°C/W typ C
NOTES: (1) Test Levels: (A) 100% tested at 25°C. Over temperature limits by characterization and simulation. (B) Limits set by characterization and simulation.
(C) Typical value only for information. (2) Junction temperature = ambient for 25°C guaranteed specifications. (3) Junction temperature = ambient at low temperature
limit: junction temperature = ambient +40°C at high temperature limit for over temperature guaranteed specifications. (4) Single amplifier SFDR limited by 2nd Harmonic.
Differential SFDR will be limited by 3rd Harmonic and will be > 15dB higher. (5) Current is considered positive out of node. V_CM is the input common-mode voltage.
(6) Slug in power package connected to –V_S plane at least 2" x 2" (50mm x 50mm) in size. See the Board Layout Guidelines Section.
®
OPA2607
2