English
Language : 

OPA2335M Datasheet, PDF (2/16 Pages) Burr-Brown (TI) – 0.05 mV/°C MAX, SINGLE-SUPPLY CMOS OPERATIONAL AMPLIFIER ZERO-DRIFT SERIES
OPA2335M
SGLS320 – SEPTEMBER 2006
www.ti.com
This integrated circuit can be damaged by ESD. Texas Instruments recommends that all integrated circuits be handled with
appropriate precautions. Failure to observe proper handling and installation procedures can cause damage.
ESD damage can range from subtle performance degradation to complete device failure. Precision integrated circuits may be
more susceptible to damage because very small parametric changes could cause the device not to meet its published
specifications.
PRODUCT
OPA2335
PACKAGE
LEAD
CDIP-8
PACKAGE/ORDERING INFORMATION
PACKAGE
DESIGNATOR
JG
SPECIFIED
TEMPERATURE
RANGE
–55°C to 125°C
PACKAGE
MARKING
OPA2335AMJG
ORDERING
NUMBER
OPA2335AMJG
PIN CONFIGURATIONS
OPA2335
Out A 1
-In A 2
+In A 3
V- 4
A
B
8 V+
7 Out B
6 -In B
5 +In B
CDIP
P0037-01
ABSOLUTE MAXIMUM RATINGS(1)
over operating free-air temperature range (unless otherwise noted)
Supply voltage
Signal input terminals
Voltage (2)
Current (2)
Output short circuit(3)
Operating temperature TA
Storage temperature TA
Junction temperature
Lead temperature (soldering, 10s)
VALUE
7V
–0.5 to (V+) + 0.5
±10
Continuous
–55 to 150
–65 to 150
150
300
UNIT
V
mA
°C
°C
°C
°C
(1) Stresses above these ratings may cause permanent damage. Exposure to absolute maximum conditions for extended periods may
degrade device reliability. These are stress ratings only, and functional operation of the device at these, or any other conditions beyond
those specified, is not implied.
(2) Input terminals are diode-clamped to the power-supply rails. Input signals that can swing more than 0.5 V beyond the supply rails should
be current-limited to 10 mA or less.
(3) Short-circuit to ground, one amplifier per package
ELECTRICAL CHARACTERISTICS
At TA = 25°C, VS = +5 V, RL = 10 kΩ connected to VS/2, and VOUT = VS/2 (unless otherwise noted)
PARAMETER
TEST CONDITIONS
MIN TYP
OFFSET VOLTAGE
Input offset voltage
VOS
VCM = VS/2
TA = 25°C
1
TA = Full
range
vs Temperature
dVOS/dT
±0.02
MAX UNIT
5 µV
10
µV/°C
2
Submit Documentation Feedback