BL-HZF39G-TRB Datasheet, PDF (7/8 Pages) BRIGHT LED ELECTRONICS CORP – White Mono-color type Suitable for all SMT assembly methods.

BRIGHT LED ELECTRONICS CORP.
SINCE 1981
BL-HZF39G-TRB
µ Soldering :
1. Manual Of Soldering
The temperature of the iron tip should not be higher than 300Ċ(572ċ) and Soldering within 3
seconds per solder-land is to be observed.
2. Reflow Soldering
Preheating : 140Ċ~160Ċ±5Ċ,within 2 minutes.
Operation heating : 260Ċ(Max.) within 10 seconds.(Max)
Gradual Cooling (Avoid quenching).
140~160Ċ
10 SEC. MAX.
260Ċ MAX.
4Ċ /SEC. MAX.
4Ċ /SEC. MAX.
OVER 2 MIN.
Time

DIP soldering (Wave Soldering) :
Preheating : 120Ċ~150Ċ,within 120~180 sec.
Operation heating : 245ĊÔ5Ċ within 5 sec.260Ċ (Max)
Gradual Cooling (Avoid quenching).
Soldering heat Max. 260 Ċ
120~150Ċ
245 ÔĊ within 5 sec.
Preheat
120~180 sec.
µ Handling :
Time
Care must be taken not to cause to the epoxy resin portion of BRIGHT LEDs while it is exposed to
high temperature.
Care must be taken not rub the epoxy resin portion of BRIGHT LEDs with hard or sharp article such
as the sand blast and the metal hook.
Ver.1.0 Page 7 of 8