CHPREZTR_14 Datasheet, PDF (2/5 Pages) Bourns Electronic Solutions – Chip Resistors

CR0603/CR0805/CR1206 - Chip Resistors
Performance Characteristics (Tests According to MIL-STD-202, MIL-R-55342B, EIA RS-396)
Test
DC Resistance
Thermal Shock
Low Temperature
Operation
Short Time
Overload
High Temperature
Exposure
Resistance to
Soldering Heat
Moisture
Resistance
Load Life
1000 Hours
Solderability
Terminal Strength
Current Noise
Humidity,
Steady State
Salt Spray
Vibration
Voltage Coefficient
Insulation
Resistance
Dielectric
Withstanding
Voltage
Drop Test
Bending Test
Sulphur Test*
Procedure
—
-40 °C, 60 minutes;
+125 °C, 60 minutes
-55 °C, 1 hour off;
45 minutes on
Rated Voltage x 2.5;
5 seconds
CR0603: 100 V max.
CR0805; 300 V max.
CR1206: 400 V max.
+125 °C; 1000 hours
260 °C, 10 seconds
Method
MIL-STD-202 303
EIA RS-396 4.4
MIL-STD-202 107
EIA RS-396 4.5
MIL-R-55342D 4.7.4
EIA RS-396 4.6
MIL-R-55342D 4.7.5
EIA RS-396 4.7
MIL-R-55342D 4.7.6
EIA RS-396 4.8
MIL-R-55342D 4.7.7
90-98 %RH; 10 cycles MIL-STD-202 106D
EIA RS-396 4.9
+70 °C; 1.5 hours on,
0.5 hours off;
1000 hours
MIL-STD-202 108
Condition D
EIA RS-396 4.12
+235 °C; 3 seconds
MIL-STD-202 208
EIA RS-396 4.11
Pull Test
MIL-R-55342D 4.7.12
Quan-Tech Model 315B MIL-STD-202 308
+40 °C; 90-95 % RH,
1344 Hours
96 hours
10-2000 Hz, 6 hours
—
Test Potential 500V
CR0603: 100V
—
MIL-STD-202 103B
Condition D
MIL-STD-202 101D
Condition A
MIL-STD-202 201A
MIL-STD-202 309
MIL-STD-202 302
Condition B
MIL-STD-202 301
1m
5 mm/90 mm; 10 sec.
50 °C H2S 3PPM 95 %
MIL-STD-202 203B
—
—
Specification
MIL-R-55342D 4.7.2
Deviation from Nominal
1%
5%
F: ≤±1 %
≤±5.0 %
MIL-R-55342D 4.7.3 ≤±0.5 % +0.05 W
≤±1 % +0.05 W
MIL-R-55342D 4.7.4 ≤±0.5 % 0.05 W
≤±1.0 % +0.05 W
MIL-R-55342D 4.7.5 ≤±1 % +0.05 W
≤±2.0 % +0.05 W
MIL-R-55342D 4.7.6 ≤±1.0 % +0.05 W
MIL-R-55342D 4.7.7 ≤±0.5 % +0.05 W
MIL-R-55342D 4.7.8 ≤±0.5 % +0.05 W
MIL-R-55342D 4.7.10 ≤±1.0 % +0.05 W
≤+2.0 % +0.1 W
≤±1.0 % +0.05 W
≤±2.0 % +0.05 W
≤±3.0 % +0.1 W
MIL-R-55342D 4.7.11 ≥95 % of area
covered
MIL-R-55342D 4.7.12 ≥500 g
MIL-R-55342D 6.6
R≤1k W; max. 1 mV/V
R≤10k W; max. 3 mV/V
R≤100k W; max. 6 mV/V
R≤1M W; max. 10 mV/V
—
≤±2.5 % +0.05 W
≥95 % of area
covered
≥500 g
R≤1k W; max. 1 mV/V
R≤10k W; max. 3 mV/V
R≤100k W; max. 6 mV/V
R≤2M W; max. 10 mV/V
≤±2.5 % +0.05 W
—
≤±1.0 % +0.2 W
≤±1.0 % +0.1 W
—
≤±0.5 % +0.1 W
≤±1.0 % +0.1 W
—
≤100 ppm/V
≤100 ppm/V
—
≥103M W
≥103M W
—
≥500 V (CR1206, CR0805)
≥300 V (CR0603)
—
≤±0.5 % +0.1 W
≤±1.0 % +0.1 W
—
≤±1 % +0.05 W
≤±1.0 % +0.05 W
—
≤±1 % +0.05 W
≤±1.0 % +0.05 W
Specifications are subject to change without notice.
The device characteristics and parameters in this data sheet can and do vary in different applications and actual device performance may vary over time.
Users should verify actual device performance in their specific applications.