96A1A-A28-A15L Datasheet, PDF (2/4 Pages) Bourns Electronic Solutions – Model 96 - 5/8 ” Square Sealed Single-Turn Panel Control

Model 96 - 5/8 ” Square Sealed Single-Turn Panel Control
Mechanical Characteristics¹
Stop Strength (1/4 ” D shaft) .............................................................................................................................................45.19 N-cm (4 lb.-in.)
(1/8 ” D shaft) .............................................................................................................................................33.89 N-cm (3 lb.-in.)
Mechanical Angle.................................................................................................................................................................................300 ° ±5 °
Torque
Starting ........................................................................................................................................... 0.3 max. above average running torque
Running Torque
Single or Dual Section (A & R Bushings) .................................................................................................. 0.21 to 1.06 N-cm (0.3 to 1.5 oz.-in.)
Single or Dual Section (C & U Bushings).................................................................................................. 0.14 to 1.06 N-cm (0.2 to 1.5 oz.-in.)
Mounting .............................................................................................................................................1.7-2.0 N-m (15-18 lb.-in.) maximum
Variation...................................................................................................................... 0.35 N-cm (0.5 oz.-in.) maximum in 45 ° shaft travel
Weight (Single Section, Metal Bushing)...............................................................................................................................12.7 grams nominal
Terminals .................................................................................................................................Printed circuit terminals, J-Hooks or solder lugs
Soldering Condition ...........................................Recommended hand soldering using Sn95/Ag5 no clean solder, 0.025 ” wire diameter.
Maximum temperature 399 °C (750 °F) for 3 seconds. Immersion wash is not recommended.
Marking ..................................................................................Manufacturer’s trademark, date code, resistance, manufacturer’s part number
Hardware...................One lockwasher and one mounting nut is shipped with each potentiometer, except where noted in the part number.
NOTE: Performance specifications do not apply to units subjected to printed circuit board immersion cleaning processes.
1_{At room ambient: +25 °C nominal and 50 % relative humidity nominal, except as noted.}
Product Dimensions
Model 96 PC Pin Terminals, In-Line
MOUNTING
SURFACE
L
12.95 ± .203
(.510 ± .008)
0.79 ± .025
(.031 ± .010)
DIA.
13.72 ± 0.38
(.540 ± .015)
1.37 ± 0.08
(.054 ± .003)
2.36 ± 0.08
(.093 ± .003)
15.88
(.625)
7.92
(.312)
SEE HOW TO ORDER
CHART FOR
BUSHING OPTIONS.
11.05 ± 0.20
(.435 ± .008)
R1
1
SEE
NEXT PAGE
2
FOR SHAFT
3
OPTIONS.
R ^1.19
(.047)
“A” STYLE
A.R. LUG
2.54
(.100)
2.54
(.100)
9.53
(.375)
15.29 ± 0.56
(.602 ± .022)
0.76 ± 0.05
(.030 ± .002)
TYP.
Shaft Flat Orientation
120 ° ± 5 ° STD.
FLAT ORIENTATION
(SHAFT AT CCW END)
1
3
CCW
2
POTENTIOMETER
TOLERANCES EXCEPT AS SHOWN:
DECIMAL
.XXX
±
(...X30X8115±)(9F.3.R68A5)CTAINOGNL±E
1/64
±5 °
DIMENSIONS:
MM
(INCHES)
BACK VIEW
Specifications are subject to change without notice.
The device characteristics and parameters in this data sheet can and do vary in different applications and actual device performance may vary over time.
Users should verify actual device performance in their specific applications.