TISP4XXXH4BJ Datasheet, PDF (1/13 Pages) Bourns Electronic Solutions – HIGH HOLDING CURRENT BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS

TISP4165H4BJ THRU TISP4200H4BJ,
TISP4265H4BJ THRU TISP4350H4BJ
HIGH HOLDING CURRENT
BIDIRECTIONAL THYRISTOR OVERVOLTAGE PROTECTORS
TISP4xxxH4BJ Overvoltage Protector Series
ITU-T K.20/21 Rating ....................... 8 kV 10/700, 200 A 5/310
High Holding Current ........................................... 225 mA min.
Ion-Implanted Breakdown Region
Precise and Stable Voltage
Low Voltage Overshoot under Surge
Device
‘4165
‘4180
‘4200
‘4265
‘4300
‘4350
V_DRM
V
135
145
155
200
230
275
V_(BO)
V
165
180
200
265
300
350
Rated for International Surge Wave Shapes
Waveshape
2/10 µs
8/20 µs
10/160 µs
10/700 µs
10/560 µs
10/1000 µs
Standard
I_TSP
A
GR-1089-CORE 500
IEC 61000-4-5 300
FCC Part 68
250
ITU-T K.20/21 200
FCC Part 68
160
GR-1089-CORE 100
Low Differential Capacitance ................................. 67 pF max.
.............................................. UL Recognized Component
SMBJ Package (Top View)
R(B) 1
2 T(A)
MDXXBG
Device Symbol
T
SD4XAA
R
Terminals T and R correspond to the
alternative line designators of A and B
Description
These devices are designed to limit overvoltages on the telephone line. Overvoltages are normally caused by a.c. power system or lightning
flash disturbances which are induced or conducted on to the telephone line. A single device provides 2-point protection and is typically used
for the protection of 2-wire telecommunication equipment (e.g., between the Ring and Tip wires for telephones and modems). Combinations of
devices can be used for multi-point protection (e.g., 3-point protection between Ring, Tip and Ground).
The protector consists of a symmetrical voltage-triggered bidirectional thyristor. Overvoltages are initially clipped by breakdown clamping until
the voltage rises to the breakover level, which causes the device to crowbar into a low-voltage on state. This low-voltage on state causes the
current resulting from the overvoltage to be safely diverted through the device. The high crowbar holding current prevents d.c. latchup as the
diverted current subsides.
How To Order
Device
Package
Carrier
For Standard
For Lead Free
Termination Finish Termination Finish
Order As
Order As
Embossed Tape Reeled TISP4xxxH4BJR
TISP4xxxH4BJ BJ (J-Bend DO-214AA/SMB)
Bulk Pack
TISP4xxxH4BJ
TISP4xxxH4BJR-S
TISP4xxxH4BJ-S
Insert xxx value corresponding to protection voltages of 165 through to 350.
*RoHS Directive 2002/95/EC Jan 27 2003 including Annex
NOVEMBER 1997 - REVISED FEBRUARY 2005
Specifications are subject to change without notice.
Customers should verify actual device performance in their specific applications.