MF-MSMF110-16-2 Datasheet, PDF (1/1 Pages) Bourns Electronic Solutions – LED PWM Dimmer

Solution Products
MF-MSMF110/16-2
CDSOT23-T12C
LED PWM Dimmer
PWM / Power
Objective
This solution is designed to protect LED
dimmer controls with 12 VDC/1 Amp and
PWM control signal from overcurrent,
overvoltage, ESD and surge events.
Solution
1 Multifuse® PPTC Resettable Fuse:
MF-MSMF110/16-2
2 TVS Diode Arrays: CDSOT23-T12C
Compliance
IEC61000-4-2 ESD Level 4 (8 kV / 15 kV)
IEC61000-4-4 EFT
IEC61000-4-5 Surge / Lightning
Alternate Recommendations
Solutions are available for lower/higher levels of
overvoltage/overcurrent protection
Benefit
This solution provides ESD/EFT/surge and
supplies overcurrent protection from potential
faults during installation within rated limits.
MF-MSMF110/16-2
LED
Dimmer _CDSOT23-T12C
Control
12 VDC
0-12 V PWM
Design Kit
The schematic above illustrates the application protection and does not constitute the complete circuit design.
Customers should verify actual device performance in their specific applications.
PN-DESIGNKIT-29
Americas: Tel [phone]
Fax [phone]
Europe: Tel [phone] Asia-Pacific: Tel [phone]
Fax [phone]
Fax [phone]
COPYRIGHT© 2012 • BOURNS, INC. • 6/12 • e/CPK1144 • “PortNote”is a registered service mark of Bourns, Inc.
“Bourns” and “Multifuse” are registered trademarks of Bourns, Inc. in the U.S. and other countries.
Bourns® PortNote® solutions provide protection
recommendations for typical port threats.
For more information, go to:
www.bourns.com
or email: [e-mail]