MPE-825A Datasheet, PDF (1/1 Pages) BOSER Technology Co., Ltd – 280W AC-DC ATX Power Supply

MPE-825A
280W AC-DC ATX Power Supply
2.0
11.0
DC OUTPUT WIRES
15.0
0.5
13.80
4-TAPPING#6-32
Features
*Input Voltage: 90~130VAC or 180~260VAC, auto switchable
*Input Frequency: 47~63Hz
*Inrush Current: Does not exceed 40A at 115VAC input or
80A at 230VAC input, at cold start 25^oC
*Ripple And Noise: Peak to peak ripple and noise for each
output is < 1% of each output voltage at rated load
115~230VAC
*Line Regulation: < +/-1% at rated load with +/-10% change
in input voltage
*Load Regulation: The output voltage load regulation is less
than the values on the table when each output loading changes
+/-40% from 60% rated load while all other outputs at 60%
rated load
*Hold Up Time: > 20ms at 115VAC input and rated load
measured from the end of the last charging pulse to when the
main output drops down to 95% output voltage
*Power Good Signal: Goes high 100~500ms after all DC
output are ready
*Power Failure: Goes low 0.5ms before any DC output falls
*Power On: TTL compatible signal (active low) used to switch
ON the main output. When power on is disconnected from
secondary common, all outputs except +5Vsb are turned off
*Efficiency: > 65% at nominal line and rated load
*Altitude: 10,000 feet
*Protection:
Short Circuit: Hiccup mode function against short circuit or
over load conditions auto restarts when fault conditions are
removed
Output: Built-in crowbar circuit automatically shuts down
outputs to avoid damaging external circuits. Trip point of
O.V.P. circuit is between 5.7~7.0V
*Temperature: 0~70^oC (operating); -40~+75^oC (storage)
*Humidity: 5~95%; non-condensing at 40^oC (operating)
*Connectors:
AC Input/Output: Meets IEC 320/CEE 22 standard
ATX Connector: Alex 9358-20 or equivalent device
3.5" Disk Drive: AMP 1-480424-0/171822-4 or equivalent
device
*Dimensions: 14.0 x 15.0 x 8.62 cm with +/-0.8mm and +/-
0.4mm tolerance between mounting holes
*MTBF: 119,695 hrs.
4.8
0.5
11.5
Safety Standards
*Safety: UL 1950 / CSA 22.2 No.234 / VDE EN60950
*EMI: FCC class B / EN55022B
*EMS: Level 3 of IEC-801, 802, 803, 804
PIN
Red
Yellow
Brown
Grey
Black
White
Orange
Purple
Green
Output
+5V
GND
+12V
-12V
+5V
GND
+12V
-12V
PWR On
Output Min.
Voltage Load
+5V 0A
+12V 0.1A
-12V 0A
-5V 0A
+3.3V 0A
+5Vsb 0A
Rated
Load
25A
10A
0.5A
0.5A
8A
0.72A
Max.
Load
30A
15A
1A
1A
15A
1.5A
Tolerance
+/-0.2V
+/-0.24V
+/-0.6V
+/-0.25V
+/-0.17V
+/-0.25V
www.boser.com.tw