BCM1500TRP Datasheet, PDF (2/2 Pages) Broadcom Corporation. – CALISTO TEST AND REFERENCE PLATFORM

CALISTO TRP OVERVIEW
TDM
TSI
InInggreressss++
HHDDLLCC
CCoonntrtorolllelerr
TDM
CALISTO CALISTO
CALISTO CALISTO
SpiceBridge
OC3
AATTMMEEggreressss
Vix
Vix
Switch Fabric
5 Gb Fabric
MMC
EPIF
2 x 100BASE-TX
PHY
PHY
MII
HDLC* Mem
ROM Flash
Motorola
PPC - 750
IBM
CPC700
Memory
Controller
PCI
Ethernet
MAC
Buffer
Io_bus (32-bit)
Mem_bus (64-bit)
256 MB
DRAM
Ethernet
MAC
JTAG/DEBUG
UART
100BASE-TX debug
PHY
The CALISTO Test and Reference Platform (TRP) is a versatile
platform that allows you to interact with the full spectrum of
Broadcom’s Voice over Packet products in advance of the completion of
their own hardware.
The CALISTO TRP provides a complete packet-to-circuit solution for
up to an OC-3’s worth of (2,016) VoP channels. It includes a 366-MHz
microprocessor for signaling support, 128 MB of 100-MHz DRAM, 8
MB FLASH, 5-Gbps packet switching fabric, two RS232 ports, eight
programmable status LEDs, one six-position mode switch, two
100BASE-FX Ethernet ports for RTP over UDP/IP, four CALISTO
daughter cards containing four CALISTOs each, and an OC-3 ATM
daughter card that supports AAL5 for packet traffic, and both AAL1 and
AAL2 for voice traffic—all in a 3 ^1/4-inch high by 16 ^5/8-inch wide box.
The CALISTO TRP includes Broadcom’s leading Gateway xChange
packet telephony software. xChange supports the full range of voice
compression modules including G.711, G.723, G.726, G.727, G.728,
G.729ABE, GSM-AMR, and GSM-EFR, as well as tone detection,
ECAN, VAD/CNG, fax and data modem relay, and Universal Port.
You can download software images of Broadcom’s Gateway xChange
reference stacks and run them at full density on the CALISTO TRP. The
TRP’s interfaces are ideal for end-to-end testing using automated test
equipment.
Furthermore, customers can insert impairments (for example, varying
jitter, packet loss, and so on) on the packet side and observe their effect
on the platform’s performance.
Your time to market is reduced because you can start writing your own
host software on the CALISTO TRP. Using CALISTO Host API, you
can port their code onto any platform with minimal effort. Writing their
own unique services you can create special service stacks, load them
onto the TRP, and test them quickly under full load.
The platform includes a rich development environment that has built-in
remote debug capabilities that further boost customers’ development
efforts. In addition to the preceding features and benefits, all of the box
schematics and drivers are available, and can be used to further shorten
your design cycle.
Broadcom^®, the pulse logo and Connecting everything^® are trademarks of
Broadcom Corporation and/or its subsidiaries in the United States and certain other countries.
All other trademarks are the property of their respective owners.
®
BROADCOM CORPORATION
16215 Alton Parkway, P.O. Box 57013
Irvine, California 92619-7013
© 2003 by BROADCOM CORPORATION. All rights reserved.
1500/1510TRP-PB02-R-4.15.03
Phone: [phone]
FAX: [phone]
Email: [e-mail]
Web: www.broadcom.com