ACPL-352J Datasheet, PDF (11/26 Pages) AVAGO TECHNOLOGIES LIMITED – 5.0 A maximum peak output current

ACPL-352J
Data Sheet
Switching Specifications (AC)
All typical values at T_A = 25°C, V_DD1 = 5V, V_DD2 – V_S = 15V, V_S – V_SS2 = 15V; All minimum and maximum specifications are at
recommended operating conditions, unless otherwise noted.
Parameter
Symbol
Min. Typ. Max. Unit Test Conditions Fig. Note
Propagation Delay Time to High V_OUTP Output
Level
Propagation Delay Time to Low V_OUTN Output
Level
Pulse Width Distortion
t_PLH
t_PHL
PWD
40
100 150
40
90
150
–50
10
50
ns
R_GP = 5Ω, R_GN = 5Ω, 16, 17, ^a
C_G = 5nF, f = 20 kHz, ²²
ns
Duty Cycle = 50%
b
I_F = 8 mA
ns
c
Propagation Delay Difference Between Any Two PDD (t_PLH – t_PHL) –75
—
75
ns
d
Parts
Propagation Delay Skew
t_PSK
—
—
60
ns
e
10% to 90% Rise Time on V_OUTP
90% to 10% Fall Time on V_OUTN
t_R
—
37
—
ns
R_GP = 5Ω, R_GN = 5Ω,
t_F
—
30
—
ns
C_G = 2nF, f = 20 kHz,
Duty Cycle = 50%,
I_F = 8 mA.
OC Blanking Time
t_OC(BLANKING)
—
0.75
1
OC Detection to 90% V_GATE Delay
t_OC(90%)
—
0.13
—
OC Detection to V_GATE = 2V Delay
t_OC(2V)
—
2.5
—
OC Detection to OC Pull Low Propagation Delay
t_OC(LOW)
—
0.25
—
μs
R_GP = 5Ω, R_GN = 5Ω, 21
f
μs
C_G = 5 nF, f = 100 Hz, ₂₁
g
Duty Cycle = 50%,
μs ^IF ^{= 8 mA, R}SS^=133Ω, 21
h
μs ^{CF = 330 pF, RF = 10 kΩ} 21
i
OC Detection to SS Pull Low Propagation Delay
t_SS(LOW)
— 0.15 0.8
μs
18, 21 ^j
OC Detection to Low Level FAULT Signal Delay
t_OC(FAULT)
—
1.7
3
μs
21
k
Output Mute Time due to Overcurrent
t_OC(MUTE)
2
3
4
ms
19, 21 ^l
Time Input Kept Low Before Fault Reset to High
t_OC(RESET)
2
3
4
ms C_F = 330 pF, R_F = 10 kΩ 19, 21 ^m
V_DD2 to UVLO High Delay
t_{PLH_UVLO}
—
15
22
μs
C_U = 330 pF,
R_U = 10 kΩ
23
n
V_DD2 to UVLO Low Delay
t_{PHL_UVLO}
—
13
30
μs
C_U = 330 pF,
R_U = 10 kΩ
23
o
V_DD2 UVLO to V_OUTP High Delay
t_{UVLO_ON}
—
3
—
μs
23
p
V_DD2 UVLO to V_OUTN Low Delay
t_{UVLO_OFF}
—
1.5
—
μs
23
q
Delay Time to V_GATE Status Check
t_GFAULT
7.5
9.5
13
μs
24
r
V_GATE Status Check to Low Level GFAULT Signal t_GFAULT(10%)
—
13.5
17
μs
Delay
C_GF = 330 pF,
R_GF = 10 kΩ
24
s
Input Logic Change to High Level GFAULT Signal t_GFAULT(90%)
—
16
25
μs
Delay
C_GF = 330 pF,
R_GF = 10 kΩ
24
t
Output High Level Common Mode Transient
|CM_H|
50
—
— kV/μs
T_A = 25°C,
u, v
Immunity
V_CM = 2000V,
V_DD1 = 5V, C_F = 330 pF,
R_F = 10 kΩ, I_F = 8 mA
Output Low Level Common Mode Transient
|CM_L|
50
—
— kV/μs
T_A = 25°C,
v,w
Immunity
V_CM = 2000V,
V_DD1 = 5V, C_F = 330 pF,
R_F = 10 kΩ, V_F = 0V
Broadcom
- 11 -