|
BCM8020 Datasheet, PDF (1/1 Pages) Broadcom Corporation. – 8-CHANNEL MULTIRATE 1.0-3.2-GBPS TRANSCEIVER | |||
|
BCM8020
®
8-CHANNEL MULTIRATE 1.0â3.2-GBPS TRANSCEIVER
FEATURES
⢠8 independent transceivers supporting multiple data rates
from 1.0 Gbps to 3.2 Gbps including 1.06 Gbps, 1.25 Gbps, 2.12
Gbps, 2.488 Gbps, 2.5 Gbps, 2.667 Gbps, 3.125 Gbps, and
3.1875 Gbps
⢠Multiconfigurable to support various operating modes
⢠Eight Independent 1.0 to 3.2-Gbps SerDes Channels
⢠Dual quad 1.0 to 3.2-Gbps SerDes with channel alignment
⢠SerDes-to-SerDes retimer mode: CML and XAUI interfaces
⢠Full mesh switching maps any XAUI port to any XGMII port
for full redundancy on both transmitter and receiver
⢠Selectable TBI DDR/RTBI or XGMII parallel interface
⢠HSTL (1.8V or 1.5V) and SSTL_2 parallel interface
⢠Low power dissipation
⢠Less than 300 mW per transceiver channel including I/O
⢠High performance programmable Rx equalization and Tx pre-
emphasis
⢠Tx pre-emphasis for interoperability with CML SerDes
⢠Rx equalization for copper interconnects
⢠Enhanced test capability
⢠Serial and parallel loopback, BIST, 10G BERT, and random
Ethernet packet generation
⢠IEEE (1149.1) JTAG
⢠Compact 23-mm à 23-mm package with no external
components required
⢠No requirement for heat sink or airflow
SUMMARY OF BENEFITS
⢠One device supports a variety of applications including
Gigabit Ethernet, 1Ã and 2Ã Fibre Channel, OC-48 SONET
(with/without FEC), Infiniband, 10-Gigabit Ethernet, 10-
Gigabit Fibre Channel, or others.
⢠Flexible architecture supports programmable configurations
enabling an aggregate data transfer rate of over 20 Mbps.
Built-in redundancy mode provides high availability to
support critical line side or backplane applications. The high-
speed to high-speed retimer mode extends the use of longer
traces on line card designs.
⢠Advanced 0.13-µ CMOS process technology provides
unparalleled performance while achieving the lowest possible
power consumption.
⢠Eases linecard designs to allow for multiple connectors or low-
cost PCB materials such as FR4.
⢠Drive PMD devices or back-plane directly with no external
clean-up circuit required.
⢠Simplifies manufacturability with integrated Built-in self-test
(BIST), high-speed and low-speed loopbacks, and
programmable PRBS generator/checker.
⢠Decreases complexity and reduces board space on multi-
channel line-card designs.
Tx
BCM8702
Rx
BCM8020
ASIC/MAC
BCM8020
2Ã XENPAK
Tx
BCM8702
2Ã XAUI
2Ã XGMII/TBI
2Ã XGMII/TBI
2Ã XAUI
Rx
2 Independent Quad SerDes Application Diagram
|