|
BCM5348M Datasheet, PDF (1/2 Pages) Broadcom Corporation. – SINGLE-CHIP L2+ MANAGED SWITCH WITH 48 10/100 PORTS + FOUR GbE PORTS | |||
|
BCM5348M
®
SINGLE-CHIP L2+ MANAGED SWITCH WITH 48 10/100 PORTS + FOUR GbE PORTS
FEATURES
SUMMARY OF BENEFITS
⢠Eighth-generation ROBO L2+ 48 FE + four SGMII interfaces
⢠Twenty-four fully integrated 10/100 PHYs
⢠Twenty-four ports providing external PHY connectivity via SSSMII
⢠Compact Field Processor (CFP) based on TCAM technology
⢠Clustering with single IP management
⢠Double Tagging supports traffic aggregation
⢠QoS packet classification supports four priority queues
⢠Port-based VLAN and 802.1Q VLAN with 4K entries
⢠Spanning Tree (IEEE 802.1D/1s/1w)
⢠MAC-based trunking with automatic link failover
⢠Port mirroring
⢠IGMP snooping Layer2/3
⢠Programmable Broadcast, Multicast, and Unknown Unicast storm
control
⢠Per port bandwidth/rate control
⢠8K MAC addresses with automatic learning and aging
⢠Protected port
⢠Multicast address table for 256 entries
⢠RvMII, MII, or GMII additional port for management
⢠EEPROM, SPI, MDC/MDIO, or EB Bus Interfaces
⢠Hardware and software reset
⢠Provides per port 70+ MIB counters with MIB Snapshot capability
⢠Jumbo frame support up to 2048 bytes
⢠JTAG
⢠Embedded 1.8V and 1.2V regulators, typical power consumption:
5W
⢠676-pin PBGA package
⢠The BCM5348M includes:
- Twenty-four 10/100 transceivers for TX/FX
- Forty-eight media access controllers
- Five Gigabit media access controllers
- Four megabit total of packet buffer and control memory
- Nonblocking switch fabric supports up to 48 FE + 4 GbE ports
⢠Flexible TCAM-based ContentAware⢠Classification technology
for affordable security and Access Control List
⢠Double Tagging enables ISP applications.
⢠Enables a new generation of lower cost FE switches with the
highest integration of enhanced L2+ features and maximum
connectivity.
⢠Optimized for WebSuperSmart⢠managed switch design.
⢠802.1Q VLAN allows segmentation of network into smaller
broadcast domains to preserve bandwidth and increase network
security.
⢠Four flexible Class of Service (CoS) queues per port ensure the
lowest latency to high-priority traffic. This enables the switch to
support a wide variety of delay-sensitive video and audio multicast
applications.
⢠IEEE 802.3ad link aggregation increases effective bandwidth and
provides redundancy of a link.
⢠IEEE 802.1X Extensive Authentication Protocol over LAN
(EAPOL) plus MAC address locking enhances network port
security.
⢠Storm and Bandwidth/Rate Control provide better traffic profile
management.
⢠Access to all internal registers through EB Bus, SPI, or MDC/
MDIO interfaces.
⢠Hardware support for implementing SNMP and RMON.
⢠Low-power consumption and embedded regulators allow simple
PCB design.
48-Port FE Switch for Small/Medium Businesses
Uplink Copper or Fiber
Printer
Cable/DSL/Wireless
Router
IP Phones
Server
|
▷ |