ACPL-K49T-000E Datasheet, PDF (1/9 Pages) Broadcom Corporation. – Wide Operating Temperature Automotive R2CouplerTM 20 kBd Digital Optocoupler Configurable as Low Power, Low Leakage Phototransistor

ACPL-K49T
Wide Operating Temperature Automotive R²Coupler^TM 20 kBd Digital
Optocoupler Configurable as Low Power, Low Leakage Phototransistor
Data Sheet
Lead (Pb) Free
RoHS 6 fully
compliant
RoHS 6 fully compliant options available;
-xxxE denotes a lead-free product
Description
The ACPL-K49T is a single channel, high temperature,
high CMR, 20 kBd digital optocoupler, configurable as
a low power, low leakage phototransistor, specifically
for use in automotive applications. The stretched SO-8
stretched package outline is designed to be compatible
with standard surface mount processes.
This digital optocoupler uses an insulating layer between
the light emitting diode and an integrated photo detector
to provide electrical insulation between input and output.
Separate connections for the photodiode bias and output
transistor collector increase the speed up to a hundred
times over that of a conventional photo-transistor coupler
by reducing the base-collector capacitance.
Avago R²Coupler isolation product provides with rein-
forced insulation and reliability that delivers safe signal
isolation critical in automotive and high temperature in-
dustrial applications
Functional Diagram
ANODE 1
CATHODE 2
NC ³
NC ⁴
8 V_CC
7 V_O
6 _NC
5 _GND
ANODE 1
CATHODE 2
NC ³
NC ⁴
8 V_O
7
6 _NC
5 _GND
Features
• High Temperature and Reliability low speed digital
interface for Automotive Application.
• 30 kV/ms High Common-Mode Rejection at V_CM = 1500 V
(typ)
• Low Power, Low Leakage Phototransistor in a “4-pin
Configuration”
• Compact, Auto-Insertable Stretched SO8 Packages
• Qualified to AEC Q100 Grade 1 Test Guidelines
• Wide Temperature Range: -40° C to +125° C
• Low LED Drive Current: 4 mA (typ)
• Low Propagation Delay: 20 ms (max)
• Worldwide Safety Approval:
– UL 1577 approval, 5 kV_RMS/1 min.
– CSA Approval
– IEC/EN/DIN EN 60747-5-5
Applications
• Automotive Low Speed Digital Signal Isolation Interface
• Inverter Fault Feedback Signal Isolation
• Switching Power Supplies Feedback Circuit
Note: The connection of a 0.1 μF
bypass capacitor between pins 5
and 8 is recommended for 5-pin
configuration.
Truth Table
LED
Vo
ON
LOW
OFF
HIGH
Note: Pins 7 and 8 are externally
shorted for 4-pin configuration.
CAUTION: It is advised that normal static precautions be taken in handling and assembly
of this component to prevent damage and/or degradation which may be induced by ESD.