MHP50 Datasheet, PDF (1/2 Pages) Bi technologies – 50W TO-220 HIGH POWER RESISTORS

50W TO-220 HIGH POWER RESISTORS
Features………………………………………………………….
ƒ Non-inductive, thin film technology.
ƒ Thermally enhanced Industry standard TO220 package.
ƒ RoHS compliant.
ƒ Low thermal resistance, 2.3 °C/W resistor hot spot to metal tab.
ƒ Complete thermal flow design available for easy implementation.
ƒ Superior vibration durability.
ƒ Small thin package for high density PCB installation.
Applications………………………………………………………
ƒ High frequency circuits and wide band / linear amplifiers.
ƒ Switch mode and industrial RF power sources.
ƒ AC motor control, electronic load and drive circuits.
ƒ Automotive.
ƒ Industrial PC modules (IPM) and measurement systems.
Specification
Dimensions
A
C
dia.M
D
MHP
J
E
G
H
F
ABC
D
E
F
G
H
J
K
L
MN
10.6 15.0 4.5 1.5 2.7 5.08 0.75 0.5 1.5 19.0 2.7 3.6 15.0
Specification
Item
Power Rating
Power Rating
Thermal Resistance
Resistance Range
Nominal Resistance Series
TCR
Tolerance
Operation Temp. Range
Max. Operating Voltage.
Dielectric Withstand Voltage
Load Life
Humidity
Temp. Cycle
Soldering Heat (Max)
Solderability
Insulation Resistance
Vibration
0.01-0.09 Ω
E6
250 ppm/°C
+/- 5% (J)
Specifications
50 Watt
2.25 Watt
2.3 °C/W
0.1-9.1 Ω
E12
100 ppm/°C
+/-1% (F) & 5% (J)
-55°C to+155°C
500V or _P.R
2000 Volts DC
∆R +/-(1.0 %+0.05 Ω)
∆R +/- (1.0 %+0.05 Ω)
∆R +/- (0.25 %+0.05 Ω)
∆R +/- (0.1 %+0.05 Ω)
Over 95% of surface
Over 1,000 MΩ
∆R +/- (0.25 %+0.05 Ω)
10-220 Ω
E24
50 ppm/°C
+/-1% (F)
Note: For resistances from 220 to 51k Ω the power rating shall be restricted to 30W.
Test Conditions
-55 to 25 °C flange temperature
Free air @ 25°C
Hot spot to Tab
Up to 51 KΩ also available
2.5 Ω and 5.0 Ω also available
-55 to +155 °C
60 seconds.
25 °C, 90 min. ON, 30 min . OFF, 1000 hours.
40°C, 90-95% RH, DC 0.1 W, 1000 hours.
-55 °C,30 min.,+155 °C,30 min., 5 cycles
250+/-5 °C, 3 seconds,
230+/-5 °C, 3 seconds.
Between terminals and tab.
1