X7AH-12F1A0 Datasheet, PDF (3/6 Pages) Bel Fuse Inc. – NON-ISOLATED DC/DC CONVERTERS 3.0V-5.5V Input 0.8V-3.3V/12A Output

NON-ISOLATED DC/DC CONVERTERS
3.0V-5.5V Input
0.8V-3.3V/12A Output
Control Specifications
Parameter
Min
Typ
Max
Remote On/Off
Signal Low (Unit Off)
-0.3V
-
0.8V
Signal High (Unit On)
2.4V
-
Vin,max
Notes
Remote on/off pin open, unit on.
Output Trim Equations
Equations for calculating the trim resistor (in kΩ) given the desired adjusted voltage (Vadj) and the nominal
output voltage of the converter (Vnom) are shown below. The Trim Down resistor should be connected between
the Trim pin and Vout. The Trim Up resistor should be connected between the Trim pin and Ground. Only one of
the resistors should be used for any given application.
R_TrimDown
=
2.0
0.9 −V_adj
− 10.187
Trim_do
R_TrimUp
=
7.0
V_adj − 0.9
−
0.187
Thermal Derating Curves
Trim_up
S7AH-12F330
V7AH-12F330
S7AH-12F250
V7AH-12F250
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel [phone] • Fax [phone] • www.belfuse.com