X7AH-01FXX0 Datasheet, PDF (3/5 Pages) Bel Fuse Inc. – NON-ISOLATED DC/DC CONVERTERS 3.0 V-5.5 V Input 12 V/0.8 A & 15 V/0.6 A Output

NON-ISOLATED DC/DC CONVERTERS
3.0 V-5.5 V Input 12 V/0.8 A & 15 V/0.6 A Output
General Specifications
Parameter
Efficiency
VO=12 V
VO=15 V
Switching Frequency
Output Trim Range
Min
84%
84%
500 kHz
90% VO
Typ
88%
88%
550 kHz
-
Max
-
-
650 kHz
110% VO
MTBF
Dimensions (surface mount)
Inches (L × W × H)
Millimeters (L × W × H)
Dimensions (vertical)
Inches (L × W × H)
Millimeters (L × W × H)
Weight
7,300,000 hours
0.78 x 0.7 x 0.32
19.81 x 17.78 x 8.13
0.7 x 0.308 x 0.65
17.78 x 7.82 x 16.51
-
5.2 g
-
Note: All specifications are typical at 25 °C unless otherwise stated.
Notes
Measured at Vin=5 V, full load
Calculated Per Bell Core TR-332 (Vin=
5 V; Vo=12 V; IO = 0.64 A; Ta = 25 °C)
Output Trim Equations
Equations for calculating the trim resistor (in kΩ) given the desired adjusted voltage (Vadj) and the nominal
output voltage of the converter (Vnom) are shown below. The Trim Down resistor should be connected between
the Trim pin and Vout. The Trim Up resistor should be connected between the Trim pin and Ground. Only one of
the resistors should be used for any given application.
R_{trim− down}
=^A
V_nom − V_adj
−B
R_{trim− up}
=
V_adj
C
− V_nom
−
D
Module
Module
Vout
Trim
Rtrim-down
GND
Vout
Trim
GND
Rtrim-up
Vnom
12
15.055
A
164.640
209.542
B
21.850
20.600
C
11.760
11.760
D
7.150
5.900
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel [phone] • Fax [phone] • www.belfuse.com