VRAE-06E1AC Datasheet, PDF (1/8 Pages) Bel Fuse Inc. – NON-ISOLATED DC/DC CONVERTERS

NON-ISOLATED DC/DC CONVERTERS
4.5 Vdc - 13.8 Vdc Input
0.59 Vdc - 5.1 Vdc / 6 A Output
VRAE-06E1AC
 Non-Isolated
 High Efficiency
 Fixed Frequency
 Low Cost
 Wide Input
RoHS Compliant Rev.B
 Under-Voltage Lockout
 Wide Trim
 OCP/SCP
 Remote On/Off
Description
The Bel VRAE-06E1AC is part of the non-isolated dc/dc converter Power Module series. The modules use a SIP
package. These converters are available in a range of output voltages from 0.59 Vdc to 5.1 Vdc over a wide
range of input voltage (VIN = 4.5 Vdc - 13.8 Vdc).The efficiency is typically 91% at 3.3 Vout (Vin=12 Vdc) at full
load.
Part Selection
Output Voltage
0.59 Vdc - 5.1 Vdc
Input Voltage
4.5 Vdc - 13.8 Vdc
Max. Output
Current
6A
Max. Output
Power
30 W
Typical
Efficiency
91%
Model Number
Active High
VRAE-06E1AC
Notes: 1. All part numbers above indicate RoHS 6. Change the second letter "R" to "7" for RoHS 5 part numbers.
2. Add “G” suffix at the end of the model numbers listed above to indicate “Tray Packaging”.
Absolute Maximum Ratings
Parameter
Min
Typ
Max
Input Supply Voltage
-0.3 V
-
15 V
Ambient Temperature
0 C
-
70 C
Storage Temperature
-55 C
-
125 C
Note: All specifications are typical at 25 C unless otherwise stated.
Notes
Input Specifications
Parameter
Operating Input Voltage
Vo,set≤3.63 V
Vo,setï¹¥3.63 V
Input Current (full load)
Input Current (no load)
Remote Off Input Current
Min
4.5 V
7.0 V
-
-
-
Typ
-
-
-
50 mA
10 mA
Max
13.8 V
13.8 V
5A
100 mA
25 mA
Input Reflected Ripple Current
(pk-pk)
-
80 mA
150 mA
Input Reflected Ripple Current
(rms)
-
25 mA
50 mA
I²t Inrush Current Transient
-
-
1 A²s
Turn on Voltage Threshold
4.15 V
4.3 V
4.45 V
Turn off Voltage Threshold
3.7 V
4.1 V
4.3 V
Note: All specifications are typical at 25 C unless otherwise stated.
Notes
An input line fuse must always be used.
With simulated source impedance of 1000
nH, 5 Hz to 20 MHz. Use a 1000 uF/25 V
AL-Cap with ESR=0.03 ohm max and
2*100 uF/25V Tan-Cap with ESR=0.013
ohm max at 100 kHz@25°C.
A 30.1K resistor is connected from Enable
to Vin
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302  Tel [phone]  Fax [phone]  www.belfuse.com