SS-36100-086 Datasheet, PDF (1/2 Pages) Bel Fuse Inc. – 36 SERIES SHIELDED PLUG WITH –A108 LOAD BAR ASSEMBLY INSTRUCTIONS

36 SERIES SHIELDED PLUG W/-A108 LOAD BAR
Bel Stewart Connector
ASSEMBLY INSTRUCTIONS
11118 Susquehanna Trail South Glen Rock, PA 17327
36 SERIES SHIELDED PLUG WITH –A108 LOAD BAR ASSEMBLY INSTRUCTIONS
Assembly steps 1 – 11:
1
Slide strain relief over cable
2
Trim off 1” to 2” of cable jacket
3
Fold back shield and drain wire
78
4
Slide ferrule over jacket and shield.
Do no trap any insulation between
shield and ferrule
12
5
Crimp ferrule. Position pairs 12
and 78 to the outside
6
Remove excess shield. Remove
plastic foil insulation if present
7
Untwist and straighten pairs
Page 1 of 2
8
Align pairs (568-B shown)
9
Place wires into –A108 load bar.
Trim wires flush with end of load
bar
MN360015-A0