SFP-1GBT-05 Datasheet, PDF (1/4 Pages) Bel Fuse Inc. – 10/100/1000Base-T RJ45 SFP Module

10/100/1000Base-T RJ45 SFP Module
SFP-1GBT-05
FEATURES / BENEFITS
• Designed with Broadcom’s BCM54616S chipset
(login at https://support.broadcom.com/Core/Login.aspx for
IC support)
• Complies with IEEE 802.3, 802.3u, and 802.3ab
specifications
• Conforms to Multi-Source Agreement (MSA) specifications
for SFP transceivers
• Supports IEEE 802.3u and IEEE 802.3ab auto–negotiation
features to allow networking equipment to automatically
determine and adjust the required settings
• Operates in extended temperature range of -40°­ to +85° C
• Automatically compensates for baseline wander by removing
the DC offset from the input signal
• Assembled with low EMI emissions IC and fully metallic
housings
• Automatic dependent interface (DI) crossover, eliminating
the need for crossover cables or cross-wire (MDIX) ports
• Bail latch provides ease of extraction
• Compact RJ45 connector assembly
• Data is scrambled to reduce radiated emission
• Power consumption is 610mW typical for 1000Base-T
• Power consumption is 320mW typical for 10/100Base-T
• The 10/100/1000Base-T physical layer IC (PHY) can
be accessed via i2c interface
APPLICATIONS
• 10/100/1000 Mbps data rate in excess of
100 meters of Category 5/5e cable
• Industrial temperature environments -40°­ to +85° C
• Networking equipment
• Switch-to-switch interface
• Routers
• Fully RoHS compliant
The BCM54616S physical layer IC (PHY) can be accessed via I²C interface:
PHY address = “ACh” for transceivers with serial number 0000000138 and higher.
PHY address = “82h” or “01” binary for transceivers with serial number 0000000137 and lower.
The EEPROM memory address = “A0h”
The Bel SFP-1GBT-05 module is an internally configured 10/100/1000Base-T SFP that requires the host system to provide
SGMII interface. The PHY interfaces directly with SerDes interface. The host interface transmits and receives serial data
differentially at 1.25 Gbps. The copper interface is full featured as advertised full/half duplex and 1000Base-T wire speed.
• SFP Transceiver identification is specified as “08h” for byte 6 in the EEPROM.
REGULATORY AND STANDARDS COMPLIANCE
• Compliant with IEEE 802.3:2000
• FCC Part 15, Class A
• EN55022 Class A (CISPR 22 Class A)
• CE
• E55024 Immunity standard and NEBS 3 ESD
©2011 Bel Fuse Inc. Specifications subject to change without notice. 04.29.11
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel [phone] • Fax [phone] • www.belfuse.com
page 1