S7DB-12C1AH Datasheet, PDF (1/6 Pages) Bel Fuse Inc. – NON-ISOLATED DC/DC CONVERTER

NON-ISOLATED DC/DC CONVERTER
3.3V Input 0.9V to 2.5V/12A Output
S7DB-12C1AH
• Non-Isolated
• Fixed frequency (300kHz)
• Low profile package (8.5mm)
• Remote Sense
• Remote On/Off (Active High Logic)
• Input Under-voltage Lockout (UVLO)
• OCP/SCP
• Wide Trim Output
Description
The S7DB-12C1AH is part of the low cost non-isolated DC/DC power converter series. The module uses a DIP
package for ease of layout and space savings, with a low profile of 8.5mm. The output is widely trimmed from
0.9V to 2.5V, and the efficiency of 2.5V output module is typically 92% at full load. Features include remote
sense, remote on/off, short circuit protection, over current protection and input under-voltage lockout.
Part Selection
Output
Input
Voltage
Voltage
0.9 – 2.5V
3.3V
Max. Output
Current
12A
Max. Output
Power
30W
Typical
Efficiency
92%
Model Number
S7DB-12C1AH
Note: Add “R” suffix at the end of the model number to indicate “Reel Packaging”, and “G” for “Tray
Packaging”.
Absolute Maximum Ratings
Parameter
Min
Typ
Input Voltage (continuous)
-0.3V
-
Output Enable Terminal Voltage
-0.3V
-
Ambient Temperature
-40°C
-
Storage Temperature
-55°C
-
Max
7V
3.9V
85°C
100°C
Notes
Input Specifications
Parameter
Min
Input Voltage
3V
Input Current (full load)
Vo=2.5V
-
Vo=1.8V
-
Vo=1.5V
-
Vo=1.2V
-
Vo=1.0V
-
Vo=0.9V
-
Input Current (no load)
-
Remote Off Input Current
Input Reflected Ripple Current
(pk-pk)
-
Typ
3.3V
-
-
-
-
-
-
-
10mA
80mA
Max
3.6V
12.0A
9.3A
8.0A
6.6A
5.7A
5.2A
150mA
20mA
160mA
Input Reflected Ripple Current
(RMS)
-
I²t Inrush Current Transient
-
Turn-on Voltage Threshold
-
Turn-off Voltage Threshold
-
25mA
0.1A²s
2.85V
2.3V
50mA
0.2A²s
-
-
Note: All specifications are typical at 25°C unless otherwise stated.
Notes
Tested with simulated source
impedance of 500Hz to 20MHz
& two 270uF/10V Oscon
capacitors with ESR=0.018
ohm max. at 100KHz
Bel Fuse Inc. 206 Van Vorst Street, Jersey City, NJ 07302 • Tel [phone] • Fax [phone] • www.belfuse.com