ZCS1-70 Datasheet, PDF (2/3 Pages) American Zettler, Inc. – HIGH CURRENT SOLENOIDS

ZCS1-70/71
GENERAL DATA
Dielelectric Strength
500 Volts
Temperature Range
-40°F~122°F (-40°C~50°C)
Mechanical Life (no load)
250,000 cycles
Electrical Life (rated load)
100,000 cycles
Mounting position (Recommended)
Plunger vertical with cap down
Continuous;
Duty Cycle
Intermittent:
At 10 sec "on" maximum requires minimum
of 60 sec "off". With a 60 sec "on" max there
is a minimum of 6 min "off."
Hardward Torque specification
44-55 in-lbs (Contact terminal);
12-18 in-lbs (Coil terminal)
Weight
398g (ZCS1-70); 483g (ZCS1-71)
MECHANICAL DATA
SPNO - Isolated Coil
.281 x 390 SLOT
5/16-UNF-2A
.485(USABLE)
LENGTH
W3.480
2.109
COIL CONNECTION
(ISOLATED)
10-32UNF-2A.470
0.900
(ZCS1-70)
1.196
(ZCS1-71)
.569
L
2.429 (ZCS1-70)
2.725 (ZCS1-71)
CIRCUIT DIAGRAM
0.48
1.082
H
2.4
APPLICATION NOTES:
1.) Not all number combinations are available. Please contact your Sales Representative for available
part numbers.
2.) Solenoid applied in battery charging circuits should be protected from higher than rated voltage during charging. The service life may
be affected by this condition and the solenoid may or may not operate the circuit as intended.
3.) Circuits should be designed to provide safe operation should the solenoid fail in either the open or closed position.
4.) A back-up wrench must be used to hold the bottom nut stationary during installation.
5/19/06