AZ762P Datasheet, PDF (1/3 Pages) ZETTLER Electronics – 20 AMP LATCHING POWER RELAY

AZ762P
20 A SPDT MINIATURE
POWER RELAY
FEATURES
• Latching relay
• Dielectric strength 4400 Vrms
• Epoxy sealed versions available
• 20 Amp switching
• High inrush current 500A / 2ms available
• UL, CUR le E44211
CONTACTS
Arrangement
Ratings
Rated Load
UL, CUR
SPDT (1 Form C)
SPST (1 Form A, 1 Form B)
Resistive load:
Max. switched power: 5000 VA
Max. switched current: 20 A
Max. switched voltage: 277 VAC
20A at 250 VAC, Resistive, 20k cycles [1]
16A at 250 VAC, Resistive, 100k cycles [1]
1.5 HP at 250 VAC, Motor, 6k cycles [1]
.5 HP at 120 & 250 VAC, Motor, 20k cycles (form A) [1]
TV-8 at 240VAC, 25k cycles (form A) [1]
Tungsten 1662W 6A at 277VAC, 6k cycles (form A) [1]
Tungsten 1800W 15A at 120VAC, 20k cycles
(form A) [1]
Electronic ballast 1800W 15A at 120VAC, 20k cycles
(form A) [1]
Standard ballast 1662W 6A at 277VAC, 6k cycles
(form A) [1]
Material
Resistance
‘T’ High Inrush Version (Form A 5.0mm Only)
3300W at 277VAC, Electronic Ballast, 20k cycles [2]
3000W at 220VAC, Tungsten, 6k cycles [2]
1500W at 347VAC, Std. Ballast, 20k cycles [2]
[1] Silver tin oxide, [2] Tungsten/Silver tin oxide
< 50 milliohms initially (at 1A, 24 VDC)
COIL
Power
At Pickup Voltage
(typical)
Max. Continuous
Dissipation
Temperature Rise
Max. Temperature
1 Coil: 256 mW
2 Coils: 384 mW
1 Coil: 0.4 W
2 Coils: 0.6 W
26°C (47°F) at nominal coil voltage
130°C (266°F)
GENERAL DATA
Life Expectancy
Mechanical
Electrical
Set Time (typical)
Reset Time (typical)
Min. Pulse Time
Max Pulse Time
Dielectric Strength
(at sea level for 1 min.)
Surge Voltage
Coil to Contact
Insulation
Resistance
Ambient Temperature
Operating
Storage
Vibration
Shock
Enclosure
Terminals
Max. Solder Temp.
Max. Solder Time
Max. Solvent Temp.
Weight
Minimum operations
1 x 10 ⁶
1 x 10 ⁵ at 16 A 250 VAC Res.
15 ms at nominal coil voltage
15 ms at nominal coil voltage
(with no coil suppression)
75ms
1 min.
4400 VAC coil to contact
1000 VAC between open contacts
10,000V (at 1.2x50 µ s)
1000 megohms min. at 20°C
500 VDC 50% RH
At nominal coil voltage
-40°C (-40°F) to 85°C (185°F)
0°C (32°F) to 40°C (104°F)
0.062" DA at 10–55 Hz
10 g
P.B.T. polyester
Tinned copper alloy, P. C.
270°C (518°F)
5 seconds
80°C (176°F)
13 g
NOTES
1. All values at 23°C (73.4°F).
2. Relay may pull in with less than “Must Operate” value.
3. Speci cations subject to change without notice.
4. Check the relay set/reset state before energizing the relay in
application.
11/17/15