AZ733W Datasheet, PDF (1/2 Pages) ZETTLER Electronics – DPST MINIATURE POWER RELAY

AZ733W
DPST MINIATURE
POWER RELAY
FEATURES
• Dielectric strength 5000 Vrms
• 1.5 mm contact gap
• Epoxy sealed version available
• 10 Amp switching — double pole contacts
• Isolation spacing greater than 8 mm
• UL Class B insulation system
• UL, CUR file E44211
• TÜV file R50129285
CONTACTS
Arrangement DPST (2 Form A)
Ratings
Rated Load
UL, CUR
TÜV
Material
Resistance
Resistive load:
Max. switched power: 300 W or 2500 VA
Max. switched current: 10 A
Max. switched voltage: 150 VDC* or 400 VAC
*Note: If switching voltage is greater than 30 VDC, special
precautions must be taken. Please contact the factory.
10 A at 250 VAC General use, 100k cycles [1][2][3]
TV-3 at 125 VAC [1]
10 A at 30 VDC, 250 VAC resistive, 100k cycles [1]
[2][3]
[1] Silver cadmium oxide [2] Silver tin oxide [3]Silver
nickel
Silver cadmium oxide, silver tin oxide or silver
nickel, Gold plating available
< 50 milliohms initially
(24 V, 1 A voltage drop method)
COIL
Power
At Pickup Voltage
(typical)
Max. Continuous
Dissipation
Temperature Rise
Temperature
450 mW
2.0 W at 20°C (68°F) ambient
40°C (83°F) at nominal coil voltage
Max. 130°C (266°F)
NOTES
1. All values at 20°C (68°F).
2. Relay may pull in with less than “Must Operate” value.
3. Specifications subject to change without notice.
GENERAL DATA
Life Expectancy
Mechanical
Electrical
Minimum operations
5 x 10⁵
1 x 10⁵ at 10 A 240 VAC Res.
Operate Time (Typical) 10 ms at nominal coil voltage
Release Time (Typical) 4 ms at nominal coil voltage
(with no coil suppression)
Dielectric Strength
5000 Vrms contact to coil
(at sea level for 1 min.) 3000 Vrms between open contacts
3000 Vrms between contact sets
Insulation
Resistance
1000 megohms min. at 20°C, 500 VDC,
50% RH
Dropout
Greater than 10% of nominal coil voltage
Ambient Temperature at nominal coil voltage
Operating
-40°C (-40°F) to 80°C (176°F)
Storage
-40°C (-40°F) to 130°C (266°F)
Vibration
0.062" DA at 10–55 Hz
Shock
10 g
Enclosure
P.B.T. polyester
Terminals
Tinned copper alloy, P.C.
Max. Solder Temp.
270°C (518°F)
Max. Solder Time
5 seconds
Max. Solvent Temp. 80°C (176°F)
Max. Immersion Time 30 seconds
Weight
18 grams
4/9/09W