AZ576 Datasheet, PDF (1/2 Pages) ZETTLER Electronics – Dielectric strength 5000 Vrms

AZ₅₇₆
20A MINIATURE
POWER RELAY
FEATURES
• Class F standard
• Dielectric strength 5000Vrms
• Low cost
• Epoxy sealed versions available
• 20 Amp switching
• UL E44211
• TUV 50333135
CONTACTS
Arrangement
SPST (1 Form A)
SPDT (1 Form C)
Ratings
Resistive load:
Max. switched power: 510W or 5540VA
Max. switched current: 20A
Max. switched voltage: 30VDC or 277VAC
*Note: If switching voltage is greater than 30 VDC, special
precautions must be taken. Please contact the factory.
Rated Load
UL, CUR
20A at 277VAC Resistive, 30k cycles, 85°C
5A at 120/277VAC Pilot Duty, 30k cycles, 85°C
1HP at 120/240/480VAC, 100k cycles, 40°C
10FLA / 60LRA at 250VAC, 100k cycles, 40°C
(N.O.) 20A at 120VAC Resistive, 100k cycles, 65°C
17A at 277VAC/30VDC Resistive, 100k cycles, 105°C
16A at 277VAC Resistive, 100k cycles, 105°C
16A at 120/277VAC General Use, 85°C
8A at 120VAC Tungsten, 30k cycles, 85°C
5A at 120VAC Ballast, 25k cycles, 85°C
1.5HP at 120VAC Motor, 100k cycles, 85°C
TV-5 120VAC, 25k (N.O. only), 85°C
TV-8 120VAC, 25k (N.O. only), 40°C.
Steady state current 8A, min. inrush (peak) current 117A
(N.C.) 17A at 277VAC/30VDC Resistive, 100k cycles, 105°C
16A at 120/277VAC General Use, 30k cycles, 85°C
TÜV
17A at 277VAC / 30VDC Resistive, 100k cycles, 105°C
Material
Silver Tin-Oxide
Resistance
COIL
Initial 100 milliohms max. at 6VDC, 1A
Power
At Pickup Voltage
(typical)
225mW, (DC, standard)
Max. Continuous
Dissipation
Temperature Rise
1.7W at 20°C (68°F) ambient
26°C (47°F) at nominal coil voltage
17°C (31°F) at nominal coil voltage, sensitive coil
Max. Temperature
130°C (266°F)
GENERAL DATA
Life Expectancy
Mechanical
Electrical
Minimumoperations
1 x 10⁷ ops Min. (no load)
1 x 10⁵ ops Min. (rated load)
Operate Time (Max)
Release Time (Max)
15ms at nominal coil voltage (<8ms typ)
8ms at nominal coil voltage (<4ms typ)
(with no coil suppression)
Dielectric Strength
5000Vrms coil to contact
(at sea level for 1 min.) 1000Vrms between open contacts
Surge Voltage
coil-contacts
10kV (1.2/50µs)
Insulation
Resistance
Dropout
1000 megohms min. at 20°C
500 VDC 50% RH
Greater than 10% of nominal coil voltage (DC)
Ambient Temperature At nominal coil voltage
Operating
-40°C (-40°F) to 105°C (221°F)
Storage
-40°C (-40°F) to 130°C (266°F)
Vibration
1.5mm DA at 10–55 Hz
Shock
10 g
Enclosure
P.B.T. polyester
Terminals
Tinned copper alloy, P. C.
Max. Solder Temp.
270°C (518°F)
Max. Solder Time
5 seconds
Max. Solvent Temp. 80°C (176°F)
Max. Immersion Time 30 seconds
Weight
12 grams
NOTES
1. All values at 20°C (68°F).
2. Relay may pull in with less than “Must Operate” value.
3. Specifications subject to change without notice.
5/16/16