ATP0574-1 Datasheet, PDF (6/7 Pages) AZ Displays – SPECIFICATIONS FOR STANDARD RESISITIVE TOUCH PANEL

AZ DISPLAYS, INC.
ATP0574-1
• 6.0 CONNECTION AND MOUNTING
The details below indicate the recommended mounting structure for panel and enclosure. The enclosure
support to fix the touch panel must be over 1.0mm I width and must be outside the view (Transparent area).
Also ensure that the enclosure does not cause miss input by touching the view area.
The following diagram shows that the enclosure edge must be between the View area and the guaranteed
active area. Ensure space is allocated for the diodes, and we recommend that the material to fix the panel
and enclosure is elastic. Special design would be required to stop water ingress. The corners of the touch
panel are conductive so do not touch any metal parts after mounting.
Location
Detect
Top View (Picture, with conductive
side down)
1.
Bottom
2.
Left
Stiffener board 10.2
5.1
3.
Top
4.
Right
(Drawing) with conductive connector and glass
side down. See page 1 for detail of connector exit
side which is left.
Transparent Area
Anit-input Area
Input Area
Shock absorber to protect
the panel (eg rubber)
(Mating connector type SFW4R-1ST: for FPC)
0.8 mm min.
Upper Case
Cut-out / avoidance of
550 surface mount diodes
0.3 to 0.1 mm
Input Panel
Wiring Area
View Area
LCD
Circuit Board
Shock absorber
for protection
Connector
• 7.0 PANEL THICKNESS (typical)
Stiffener Board
Conductive Face
Thickness of Glass 1.1mm
Page 6 of 7