PM070WT1 Datasheet, PDF (21/23 Pages) AZ Displays – TECHNICAL SPECIFICATION

PM070WT1
15. Reliability Test
No
Test Item
Test Condition
Remark
1 High Temperature Storage Test
Ta = +80к, 240 hrs
2 Low Temperature Storage Test
Ta = -30к, 240 hrs
3 High Temperature Operation Test
Ta = +70к, 240 hrs
4 Low Temperature Operation Test
Ta = -20к, 240 hrs
5
High Temperature & High Humidity
Operation Test
Ta = +60к, 90%RH, 240 hrs
(No Condensation)
6
Thermal Cycling Test
(non-operating)
-30к +80к, 100 Cycles
30min 30min
FrequencyΚ10 ~ 55 H_{Z ,}
7
Vibration Test
(non-operating)
AmplitudeΚ1 mm
Sweep time: 11 min
Test Period: 6 Cycles for each direction of X, Y,
Z
8
Shock Test
(non-operating)
100G, 6ms
Direction: ̈́X, ̈́Y, ̈́Z Cycle: 3 times
9
Electrostatic Discharge Test
(non-operating)
200pF, 0Ó¨
̈́200V
1 time / each terminal
Ta: ambient temperature
Note : The protective film must be removed before temperature test.
[Criteria]
1. Main LCD should normally work under the normally condition no defect of function,
screen quality and appearance (including : mura ,line defect ,no image).
2. After the temperature and humidity test, the luminance and CR (Contrast
ratio) ,should not be lower than minimum of specification.
3. After the vibration and shock test , can’t be find chip ,broken.
The information contained herein is the exclusive property of Prime View International Co., Ltd. and shall not be
distributed, reproduced, or disclosed in whole or in part without prior written permission of Prime View International Co.,
Ltd.
Page:21