ATM0700D6J-CT Datasheet, PDF (21/23 Pages) AZ Displays – SPECIFICATIONS FOR LIQUID CRYSTAL DISPLAY

ATM0700D6J-CT(AZ DISPLAYS)TFT MODULE VER1.0
9. INSPECTION SPECIFICATION
1. SCOPE SPECIFICATIONS CONTAIN
1.1 DISPLAY QUALITY EVALUATION
1.2 MECHANICS SPECIFICATION
2. SAMPLING PLAN
UNLESS THERE IS OTHER AGREEMENT, THE SAMPLING PLAN FOR INCOMING INSPECTION SHALL FOLLOW
MIL-STD-105E.
2.1 LOT SIZE: QUANTITY PER SHIPMENT AS ONE LOT (DIFFERENT MODEL AS DIFFERENT LOT ).
2.2 SAMPLING TYPE: NORMAL INSPECTION, SINGLE SAMPLING.
2.3 SAMPLING LEVEL: LEVEL II.
2.4 AQL: ACCEPTABLE QUALITY LEVEL
MAJOR DEFECT: AQL=0.65
MINOR DEFECT: AQL=1.0
3. PANEL INSPECTION CONDITION
3.1 ENVIRONMENT:
ROOM TEMPERATURE: 25±5°C.
HUMIDITY: 65±5% RH.
ILLUMINATION: 300 ~ 700 LUX.
3.2 INSPECTION DISTANCE:
35±5 CM
3.3 INSPECTION ANGLE:
THE VISION OF INSPECTOR SHOULD BE PERPENDICULAR TO THE SURFACE OF THE MODULE.
3.4 INSPECTION TIME：
PERCEPTIBILITY TEST TIME: 20 SECONDS MAX.
4. DISPLAY QUALITY
4.1 FUNCTION RELATED:
THE FUNCTION DEFECTS OF LINE DEFECT, ABNORMAL DISPLAY, AND NO DISPLAY ARE CONSIDERED
MAJOR DEFECTS.
4.2 BRIGHT/DARK DOTS:
Note: 1:
The definition of dot: The size of a defective dot over 1/2 of whole dot is regarded as one defective dot.
Bright dot: Dots appear bright and unchanged in size in which LCD panel is displaying under black pattern.
The bright dot defect must be visible through 2% ND filter
Dark dot: Dots appear dark and unchanged in size in which LCD panel is displaying under pure red, green, blue
pattern.
4.3 Pixel Definition:
Note 1:
If pixel or partial sub-pixel defects exceed 50% of the affected pixel or sub-pixel area, it shall be considered as1
defect.
Note 2:
There should be no distinct non-uniformity visible through 2% ND Filter within 2 sec inspection times.
AZ DISPLAYS
20