AXIOM1000 Datasheet, PDF (1/4 Pages) Advanced XTAL Products – UHF Ultra-Low Phase Noise OCXO in Connectorized Package

Designed and
Manufactured
in Germany
Specification AXIOM1000
Rev.: 1 Date: 2014-08-26
Oscillator type: UHF Ultra-Low Phase Noise OCXO in Connectorized Package
Parameter
min. typ. max. Unit Condition
Frequency range
Standard frequencies
Frequency stability
Initial tolerance @ +25°C
vs. operating temperature range
vs. supply voltage variation (pushing)
vs. load change (pulling)
Long term (aging) per day
Long term (aging) 1^st year
Frequency adjustment range
Electronic Frequency Control (EFC)
EFC voltage V_C
EFC slope (∆f / ∆V_C)
EFC input impedance
RF output
Signal waveform
Load R_L
Output level
Harmonics
Sub-harmonics (multiples of f_OUT/10)
Spurious
Warm-up time @ +25°C
Phase noise @ 1000 MHz (Note 4)
Supply voltage V_S
Current consumption (steady state)
Current consumption (warm-up)
300
1500 MHz
1000.000
MHz
±300 ppb
Option 1 & 2
See tables 1 & 2
±10 ppb
±5 ppb
±1
±2 ppb
±100 ±200 ppb
@ V_C = 5.0 V
steady state
V_S ±5%
R_L ±5%
after 30 days operation
after 30 days operation
±1
±2
ppm
1.0
5.0
9.0 V
Positive
100
kΩ
Sine wave
50
+11 +13 +15
-40
-35
-45
-40
-90
5
-115 -110
-143 -140
-150 -145
-150
11.4 12.0 12.6
300
700
Ω
dBm
dBc
dBc
dBc
min
dBc/Hz
dBc/Hz
dBc/Hz
dBc/Hz
V
mA
mA
±5%
(Note 2)
(Note 3)
∆f_final/f₀ < ±0.1 ppm
@ 100 Hz
@ 1 kHz
@ 10 kHz
@ ≥100 kHz
(Note 5)
@ +25°C
Enclosure (see drawing) (LxWxH)
50.0x50.0x21.0 max. mm
Weight
60 g
Packing
Palette
Notes:
1.
2.
3.
4.
5.
Terminology and test conditions are according to IEC60679-1 and MIL-PRF-55310, unless otherwise stated
Other output level on request
Depending on frequency multiplication factor may be lower or higher than 10
Please consult factory for phase noise of other frequencies
Other supply voltages on request
GmbH & Co. KG
Roemerring 9
D-74821 Mosbach
Germany
AXIOM1000 Rev.1
Drawing D0
Page 1(4)
www.axtal.com
fon: [phone]
fax: [phone]
E-mail: [e-mail]