AXE40 Datasheet, PDF (1/3 Pages) Advanced XTAL Products – Low Phase Noise VHF/UHF SPXO

Designed and
Manufactured
in Germany
Specification AXE40
Rev.: 1
Oscillator type: Low Phase Noise VHF/UHF SPXO (no PLL)
with LVPECL or Sine Wave Output
Date: 2014-04-04
Parameter
min. typ. max. Unit Condition
Frequency range
Frequency stability
Initial tolerance
vs. operating temperature range
vs. supply voltage variation
vs. load change
Long term (aging) per year
Frequency adjustment range
Electronic Frequency Control (EFC)
RF output
Signal waveform
Output Level (Option 1 = “S”)
Harmonics (Option 1 = “S”)
Sub-harmonics (Note 4)
Output Levels (Option 1 = “L”)
HIGH (VOH)
LOW (VOL)
Supply voltage V_S
Current consumption (steady state)
Operating temperature range
60
400 MHz
ppm
±5 ppm
±10 ppm
±2 ppm
±2 ppm
±2 ppm
N.A.
ppm
Sine Wave
LVPECL Complementary
+0
dBm
-30 dBc
-40 dBc
2.215
1.470
3.15
4.75
-20
2.345
1.595
3.3
5.0
2.420 V
1.745 V
3.45 V
5.25 V
40 mA
+70 °C
(Note 2)
V_S ±5%
Load ±5%
@ 40°C
on request
Option 1 = “S”
Option 1 = “L”
R_L = 50 Ω (Note 3)
RL = 50 Ω to VS - 2 V
(Note 5)
Option 2 = “33”
Option 2 = “50”
(Note 6)
Enclosure (see drawing) (LxWxH)
20.5x20.5x12.5 max. mm
IEC 60679-3 CO 41
Weight
8g
Packing
Palette
IEC 60286-3
Notes:
1. Terminology and test conditions are according to IEC60679-1 and MIL-PRF-55310, unless otherwise stated
2. Other stabilities over temperature on request
3. Higher output level on request
4. For frequencies above 100 MHz sub-harmonics may be present. Please consult factory
5. Output levels vary 1:1 with V_S
6. Current consumption depends on frequency, supply voltage and output option
Absolute Maximum Ratings
Parameter
Supply Voltage V_S
Storage Temperature
min.
max. Unit
-0.5
V_S + 10% V
-55
+125 °C
Condition
V_S to GND
GmbH & Co. KG
Roemerring 9
D-74821 Mosbach
Germany
AXE40 Rev.1
Drawing D2
Page 1(3)
www.axtal.com
fon: [phone]
fax: [phone]
E-mail: [e-mail]